2004 Toyota Tacoma Owners Manual - Page 201

'04 Tacoma U (L/O 0309) Installing front license plate (four- wheel drive models and Pre Runner) Valance panel Longer tapping screws The 4 tapping screws are enclosed in a plastic bag in the glove box. If your vehicle was not equipped with the screws at delivery, contact your Toyota dealer. Shorter Front license plate tapping screws CAUTION Make sure the floor mat is properly placed on the floor carpet. If the floor mat slips and interferes with the movement of the pedals during driving, it may cause an accident. Install the front license plate using the following procedure: 1. Remove and discard the front license plate frame (if installed on the vehicle at delivery). 2. Align the holes on the front license plate with the dimples on the valance panel. 3. Install the two longer tapping screws through the upper holes, and the two shorter tapping screws through the lower holes of the license plate, into the dimples on the valance panel. Do not drill holes in the dimples on the valance panel. 201 2004 TACOMA from Sep. '03 Prod. (OM35814U)