2004 Toyota Tacoma Owners Manual - Page 296

'04 Tacoma U (L/O 0309) Checking brake fluid To check the fluid level, simply look at the see- through reservoir. The level should be between the "MAX" and "MIN" lines on the reservoir. It is normal for the brake fluid level to go down slightly as the brake pads wear. So be sure to keep the reservoir filled. If the reservoir needs frequent refilling, it may indicate a serious mechanical problem. If the level is low, add SAE J1703 or FMVSS No.116 DOT 3 brake fluid to the brake reservoir. Refilling brake fluid: Vehicles without vehicle stability control system- Remove and replace the reservoir cap by hand. Fill the brake fluid to the dotted line. This brings the fluid to the correct level when you put the cap back on. Use only newly opened brake fluid. Once opened, brake fluid absorbs moisture from the air, and excess moisture can cause a dangerous loss of braking. Vehicles with vehicle stability control system- 1. Turn the ignition switch off. 2. Depress the brake pedal more than 40 times. 3. Remove the reservoir cover by hand. Add brake fluid up to the "MAX" line. If you do not follow the procedure above, the reservoir may overflow. Use only newly opened brake fluid. Once opened, brake fluid absorbs moisture from the air, and excess moisture can cause a dangerous loss of braking. Vehicles without vehicle stability control system CAUTION Take care when filling the reservoir because brake fluid can harm your eyes and damage painted surfaces. If fluid gets in your eyes, flush your eyes with clean water immediately. If you still feel uncomfortable with your eyes, go to the doctor. NOTICE Vehicles with vehicle stability control system If you spill the fluid, be sure to wash it off with water to prevent it from damaging the parts or paint. 296 2004 TACOMA from Sep. '03 Prod. (OM35814U)