2005 Toyota Highlander Owners Manual - Page 121

'05 HIGHLANDER_U (L/O 0409) Headlights and turn signals (without automatic light control system) High−Low beams-For high beams, turn the headlights on and push the lever away from you (position 1). Pull the lever toward you (position 2) for low beams. The headlight high beam indicator light (blue light) on the instrument panel will tell you that the high beams are on. Flashing the high (position 3)-Pull the back. The high beam when you release the beam headlights lever all the way headlights turn off lever. TURN SIGNALS To signal a turn, push the headlight/ turn signal lever up or down to position 1. The key must be in the "ON" position. The lever automatically returns after you make a turn, but you may have to return it by hand after you change lanes. To signal a lane change, move the lever up or down to the pressure point (position 2) and hold it. If the turn signal indicator lights (green lights) on the instrument panel flash faster than normal, a front or rear turn signal bulb is burned out. See "Replacing light bulbs" on page 400 in Section 7 −3. HEADLIGHTS To turn on the following lights: Twist the headlight/turn signal lever knob. Position 1-Parking, tail, license plate, side marker and instrument panel lights Position above 2-Headlights and all of the You can flash the high beam headlights with the knob turned to "OFF". The lights automatically turn off when the driver's door is opened with the ignition turned off. To turn them on again, turn the key to the "ON" position or actuate the headlight switch. If you are going to park for over one week, make sure the headlight switch is off. 121 2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)