2005 Toyota Highlander Owners Manual - Page 164

'05 HIGHLANDER_U (L/O 0409) To initialize the system, perform the following: 1. Park the vehicle at a safe place and apply the parking brake. Stop the engine. 2. Adjust the pressure of all the installed tires to the specified level. (See "Tires" on page 410 in Section 8.) 3. Turn the ignition key to "ON". If the low tire pressure warning light comes on, push the reset switch for a few seconds and make sure the warning light goes off. 4. Push and hold the reset switch until the low tire pressure warning light blinks three times. Initialization is completed after driving at the speeds of 30 km/h (19 mph) or over for more than one hour. If the following driving conditions are satisfied, initialization will be completed in about one hour. If the low tire pressure warning light does not blink when you push and hold the reset switch, have the low pressure warning system checked at your Toyota dealer. When the warning light blinks twice every second while driving, you may be unable to reset the system. In this case, set the system again according to the above procedure. When initializing the system, make sure the low tire pressure warning light blinks three times. If the warning light does not blink three times, initializing will be failed and the tire pressure warning system will not function properly. Do not push the reset switch without adjusting the tire inflation pressure to the specified level. Otherwise, the low tire pressure warning light may not come on even if the tire pressure is low, or it may come on when the tire inflation pressure is actually normal. If you push the reset switch while the vehicle is moving, initialization is not performed. D The vehicle speed is between 50 km/h (31 mph) and 100 km/h (62 mph). D The roads are dry, smooth and straight. D The number of passengers is 1 or 2 (including driver). 164 2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)