2005 Toyota Highlander Owners Manual - Page 276

'05 HIGHLANDER_U (L/O 0409) (a) Programming the HomeLinkR The HomeLinkR in your vehicle has 3 buttons and you can store one program for each button. To ensure correct programming into the HomeLinkR, install a new battery in the hand−held transmitter prior to programming. The battery side of the hand−held transmitter must be pointed away from the HomeLinkR during the programming process. For Canadian users, follow the procedure in "Programming an entrance gate/programming all devices in the Canadian market". 1. Decide which of 3 HomeLinkR buttons you want to program. 2. Place your hand−held garage transmitter 25 to 75 mm (1 to 3 in.) away from the surface of the HomeLinkR. Keep the indicator light on the HomeLinkR in view while programming. 3. Simultaneously press and hold the hand−held garage transmitter button along with the selected HomeLinkR button. 4. When the indicator light on the HomeLinkR changes from a slow to a rapid flash after 20 seconds, you can release both buttons. 5. Test the operation of the HomeLinkR by pressing the newly programmed button. If programming a garage door opener, check to see if the garage door opens and closes. If the garage door does not operate, identify if your garage transmitter is of the "Rolling Code" type. Press and hold the programmed HomeLinkR button. The garage door has the rolling code feature if the indicator light (on the HomeLinkR) flashes rapidly and then remains lit after 2 seconds. If your garage transmitter is the "Rolling Code" type, proceed to the heading "Programming a rolling code system". 6. Repeat steps 2 through 5 for each remaining HomeLinkR button to program another device. Programming a rolling code system If your device is "Rolling Code" equipped, it is necessary to follow steps 1 through 4 under the heading "Programming the HomeLinkR" before proceeding with the steps listed below. 1. Locate the "training" button on the ceiling mounted garage door opener motor. The exact location and color of the button may vary by brand of garage door opener. Refer to the owner's guide supplied by the garage door opener manufacturer for the location of this "training" button. 2. Press the "training" button on the ceiling mounted garage door opener motor. Following this step, you have 30 seconds in which to initiate step 3 below. 3. Press and release the vehicle's programmed HomeLinkR button twice. The garage door may open. If the door does open, the programming process is complete. If the door does not open, press and release the button a third time. This third press and release will complete the programming process by opening the garage door. 276 2005 HIGHLANDER from Nov. '04 Prod. (OM48570U)