2005 Toyota Land Cruiser Owners Manual - Page 309

Checking the engine oil level Low level Full level NOTICE Be careful not to drop engine oil on the vehicle components. If the oil level is below or only slightly above the low level, add engine oil of the same type as already in the engine. Remove the oil filler cap and add engine oil in small quantities at a time, checking the dipstick. We recommend that you use a funnel when adding the oil. 3. Standing up on the left side of the vehicle, reinsert the dipstick in the direction so that the "ENGINE OIL" on top should be read correctly and push it in as far as it will go, or the reading will not be correct. 4. Pull the dipstick out and look at the oil level while holding a rag under the end. The approximate quantity of oil needed to raise the level between low and full on the dipstick is indicated below for reference. When the level reaches within the correct range, install the filler cap hand−tight. Oil quantity, L (qt., Imp.qt.): 1.5 (1.6, 1.3) Add oil O.K. Too full With the engine at operating temperature and turned off, check the oil level on the dipstick. 1. To get a correct reading, the vehicle should be on level ground. After turning off the engine, wait a few minutes for the oil to drain back into the bottom of the engine. 2. Pull the dipstick out, hold a rag under the end and wipe it clean. NOTICE z Be careful not to spill engine oil on the vehicle components. z Avoid overfilling, or could be damaged. the engine CAUTION Be careful not to touch the hot exhaust manifold. z Check the oil level on the dipstick once again after adding the oil. 296