2005 Toyota Land Cruiser Navigation Manual - Page 148

AUDIO SYSTEM (b) Presetting a station (c) Selecting a station Your Toyota has an electronic tuning radio (ETR). Tune in the desired station using one of the following methods. Preset tuning: Touch the switch (1-6) or push the "Ɯ" or "Ɲ" side of the "CH" button for the station you want. The switch (1-6) is highlighted in green and station frequency appears on the display. Manual tuning: Turn the "TUNE" knob briefly. Each time you turn the knob, the radio will step up or down to another frequency. Seek tuning: Push the "Ɯ" or "Ɲ" side of the "SEEK" button and hold it until you hear a beep. The radio will begin seeking up or down for a station of the nearest frequency and will stop on reception. Each time you push the button, the stations will be searched out one after another. lxb001a lxb001a 1. Tune in the desired station. 2. Touch one of the station selector switches (1-6) and hold it until a beep is heard. This sets the station to the switch and the frequency appears on the switch. Each switch can store FM1, FM2 and AM. To change the preset station to a different one, follow the same procedure. The preset station memory is cancelled when the power source is interrupted by battery disconnection or a blown fuse. Scan tuning:Touch the "SCAN" switch briefly. "SCAN" appears on the display. The radio will find the next station up or down the band, stay there for a few seconds, and then scan again. To select a station, touch the "SCAN" switch a second time. Preset scan tuning: Touch the "SCAN" switch and hold it until you hear a beep. "P. SCAN" appears on the display. The radio will tune in the next preset station up or down the band, stay there for a few seconds, and then move to the next preset station. To select a station, touch the "SCAN" switch a second time. 148