2005 Toyota Tacoma Owners Manual - Page 352

05 02.25 The following instructions for checking tire inflation pressure should be observed: D The pressure should be checked only when the tires are cold. If your vehicle has been parked for at least 3 hours and has not been driven for more than 1.5 km or 1 mile since, you will get an accurate cold tire inflation pressure reading. D Always use a tire pressure gauge. The appearance of a tire can be misleading. Besides, tire inflation pressures that are even just a few pounds off can degrade ride and handling. D Do not bleed or reduce tire inflation pressure after driving. It is normal for the tire inflation pressure to be higher after driving. D Never exceed the vehicle capacity weight. Passenger and luggage weight should be located so that the vehicle is balanced. Tire pressure gauge LS72003 5. After completing the tire inflation pressure measurement and adjustment, apply soapy water to the valve and check for leakage. 6. Install the tire valve cap. If a gauge and air pump are not available, have your vehicle checked by your Toyota dealer. CAUTION Be sure to reinstall the tire valve caps. Without the valve caps, dirt or moisture could get into the valve core and cause air leakage. If the caps have been lost, have new ones put on as soon as possible. Incorrect tire inflation pressure may waste fuel, reduce the comfort of driving, reduce tire life and make your vehicle less safe to drive. If a tire frequently needs refilling, have it checked by your Toyota dealer. INSPECTION AND ADJUSTMENT PROCEDURE 1. Remove the tire valve cap. 2. Press the tip of the tire pressure gauge to the tire valve. 3. Read the pressure using the graduations of the gauge. 4. In case the tire inflation pressure is not within the prescribed range, insert the compressed air from the valve. In case of applying too much air, press the center of the valve and release the air to adjust. 352 2005 TACOMA from Mar. '05 Prod. (OM35862U)