2006 Toyota Avalon Owners Manual - Page 23
2006 Toyota Avalon Manual
Page 23 highlights
'06 AVALON_U (L/O 0508) -Switching beep sound (with key cylinder- type ignition switch only) Pushing the switch blows the horn intermittently and flashes the headlights, tail lights and interior light. Vehicles with smart key system only- When pushing the switch, the indicator light flashes. The alarm switch is used to deter vehicle theft when you witness anyone attempting to break into or damage your vehicle. The alarm will last for one minute. To stop the alarm midway, push the switch once again, unlock a door with the transmitter, or set the ignition switch to ON. If the key is in the ignition (vehicles with key cylinder- type ignition switch) or the ignition switch is set at ACC or ON (vehicles with smart key system), the alarm does not work. This alarm function can be disabled. For details, contact your Toyota dealer. You can switch the beep sound on and off. (The beep sound is on initially and after battery replacement.) To switch the beep sound on and off: With the driver's door opened- 1. Insert the ignition key and remove it. 2. Within 5 seconds, switch to ON. set the ignition -Replacing battery (with key cylinder- type ignition switch) For replacement, use a CR2016 lithium battery or equivalent. CAUTION Special care should be taken to prevent small children from swallowing the removed transmitter battery or components. 3. After 10 seconds, push any switch on the transmitter twice within 10 seconds. Two beep sounds inform you that the program has been switched on or off. If this procedure is not followed exactly, the beep sound will not operate as expected. Check the beep sound on/off operation by pushing the transmitter switch after you finish this procedure. If the beep does not operate as expected, repeat this procedure from step 1. NOTICE z When replacing the transmitter battery, be careful not to lose the components. z Replace only with the same or equivalent type recommended by a Toyota dealer. z Dispose of used batteries according to the local laws. Replace the transmitter battery by following these procedures: 23