2006 Toyota Sequoia Owners Manual - Page 169

'06_SEQUOIA_U (L/O 0508) (l) Low Tire Pressure Warning Light This light warns that the tire pressure of one or more of your tires (including the spare tire) is low. The light comes on when the ignition key is turned to the "ON" position. It goes off after a few seconds. This indicates that the tire pressure warning system is functioning properly. If the warning light comes on, stop your vehicle in a safe place as soon as possible and check that the inflation pressure of all tires (including the spare tire) is as specified on the tire and loading information label. (See "Checking tire inflation pressure" on page 431 in Section 7 −2.) The light should go off a few minutes after the tire pressure is adjusted. If the warning light blinks, the tire pressure warning system may be malfunctioning. Contact your Toyota dealer. For details, see "Tire pressure warning system" on page 198 in Section 1 −7. (m) Low Windshield Washer Fluid Level Warning Light This light warns that the windshield washer fluid level is too low. Add washer fluid at your earliest opportunity. (For instructions, see "Adding washer fluid" on page 446 in Section 7−3.) (n) Engine Oil Replacement Reminder Light (for vehicles sold in U.S.A.) This light acts as a reminder to replace the engine oil. This light will come on when the ignition key is turned to "ON" and will go off after about a few seconds. When you drive for about 7200 km (4500 miles) after the engine oil replacement, this light illuminates for about 3 seconds and then flashes for about 12 seconds with the ignition key turned to the "ON" position. If you continue driving without replacing the engine oil, and if the distance driven exceeds 8000 km (5000 miles), the light will come on after the ignition key is turned to "ON" position. The light will remain on thereafter. If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road conditions. If the light comes on, replace it as soon as possible. The system must be reset after the engine oil replacement. Reset the system by the following procedure: 1. Turn the ignition key to the "ACC" or "LOCK" position with the odometer reading shown. (For details, see "Odometer and two trip meters" on page 160 in this Section.) 2. Turn the ignition key to the "ON" position while holding down the trip meter reset knob. Hold down the knob for at least 5 seconds. The odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing. (o) Key Reminder Buzzer This buzzer acts as a reminder to remove the key when you open the driver's door with the ignition key in the "ACC" or "LOCK" position. 169