2007 Toyota Corolla Owners Manual - Page 284

'07 Corolla_U (L/O 0608) Replacing light bulbs- The following illustrations show how to gain access to the bulbs. When replacing a bulb, make sure the ignition switch and light switch are off. Use bulbs with the wattage ratings given in the table. Vehicles with rear spoiler-The high mounted stoplight consists of a number of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to have the light replaced. The inside of the lens of exterior lights such as headlights may temporarily fog up when the lens becomes wet in the rain or in a car wash. This is not a problem because the fogging is caused by the temperature difference between the outside and inside of the lens, just like the windshield fogs up in the rain. However, if there is a large drop of water on the inside of the lens, or if there is water pooled inside the light, contact your Toyota dealer. Light bulbs Headlights (high beam) Headlights (low beam) Parking/front side marker/front turn signal lights Front fog lights Rear side marker and stop/tail lights Rear turn signal lights Back−up lights High mounted stoplight License plate lights Interior light Bulb No. 9005 9006 W 65 55 Type A B 3157A 9006 3157 27/8 C B D C D D D E CAUTION 55 27/8 27/8 18 18 5 8 D To prevent burning yourself, do not replace the light bulbs while they are hot. 3157A 921 921 - D Halogen bulbs have pressurized gas inside and require special handling. They can burst or shatter if scratched or dropped. Hold a bulb only by its plastic or metal case. Do not touch the glass part of a bulb with bare hands. - NOTICE Only use a bulb of the listed type. 272 2007MY COROLLA from Oct. '06 Prod. (OM12B32U)