2007 Toyota Sequoia Owners Manual - Page 218

06 06.02 NOTICE z Do not use liquid sealants for a flat tire as tire pressure warning valve and transmitter will be damaged. z When the tires must be repaired or replaced, have them repaired or replaced by the nearest Toyota dealer or an authorized tire dealer. The tire pressure warning valves and transmitters will be affected by the installation or removal of tires. D If the ID code on the tire pressure warning valves and transmitters is not registered in the tire pressure warning ECU. D If electronic devices or facilities using u16032 similar radio nearby. wave frequencies are D If a radio set at similar frequencies is in use in the vehicle. D If a window tint that affects the radio wave signals is installed. D If there is a lot of snow or ice on the IF THE TIRE PRESSURE WARNING LIGHT BLINKS (COMES ON AFTER BLINKING FOR 1 MINUTE)...If the tire pressure warning light blinks (comes on after blinking for 1 minute) when the ignition key is turned to the "ON" position, the tire pressure warning system is not working properly. The system will be disabled in the following conditions: (When the condition becomes normal, the system will work properly.) vehicle, in particular around the wheels or wheel housings. D If non−genuine Toyota wheels are used. D If tire chains are used. D If the spare tire is in a location subject to poor radio wave signal reception. D If the tire inflation pressure is more than 500 kPa (5 kgf/cm2 or bar, 70 psi) or higher than the specified level. If the tire pressure warning light continues to blink (comes on after blinking for 1 minute) when the ignition key is turned to the "ON" position, have the system checked by your Toyota dealer. D If tires not equipped with tire pressure warning used. valves and transmitters are 2007 SEQUOIA from Sep. '06 Prod. (OM34457U) 203