2007 Toyota Sequoia Owners Manual - Page 447

06 05.31 Checking power steering fluid Remove and replace the reservoir cap by hand. Fill the brake fluid to the dotted line. This brings the fluid to the correct level when you put the cap back on. Use only newly opened brake fluid. Once opened, brake fluid absorbs moisture from the air, and excess moisture can cause a dangerous loss of braking. Clean all dirt from the outside of the reservoir tank and look at the fluid level. If the fluid is cold, the level should be in the "COLD" range. Similarly, if it is hot, the fluid level should be in the "HOT" range. If the level is at the low side of either range, add automatic transmission fluid DEXRONr II or III to bring the level within the range. To remove the reservoir cap, turn it counterclockwise and lift up. To reinstall it, turn it clockwise. After replacing the reservoir cap, visually check the steering box case, vane pump and hose connections for leaks or damage. Close If hot O.K. Open If cold O.K. u72003 CAUTION Take care when filling the reservoir because brake fluid can harm your hands or eyes. If fluid gets on your hands or in your eyes, flush the affected area with clean water immediately. If you still feel uncomfortable with your hands or eyes, go to the doctor. If hot add If cold add Check the fluid level through the reservoir. If necessary, add automatic transmission fluid DEXRONr II or III. If the vehicle has been driven around 80 km/h (50 mph) for 20 minutes (a little more in frigid temperatures), the fluid is hot (60_C-80_C or 140_F-175_F). You may also check the level when the fluid is cold (about room temperature, 10_C-30_C or 50_F-85_F) if the engine has not been run for about five hours. CAUTION The reservoir tank may be hot so be careful not to burn yourself. NOTICE If you spill some of the fluid, be sure to wipe it off to prevent it from damaging the parts or paintwork. NOTICE Avoid overfilling, or the power steering could be damaged. 432 2007 SEQUOIA from Sep. '06 Prod. (OM34457U)