2007 Toyota Sequoia Owners Manual - Page 456

06 05.31 Replacement with used wheels is not recommended as they may have been subjected to rough treatment or high mileage and could fail without warning. Also, bent wheels which have been straightened may have structural damage and therefore should not be used. Never use an inner tube in a leaking wheel which is designed for a tubeless tire. Initial adjustment of the tire pressure warning system is necessary after you have replaced your wheels. See "Tire pressure warning system" on page 200 in Section 1−7. Aluminum wheel precautions D When installing aluminum wheels, check that the wheel nuts are tight after driving your vehicle the first 1600 km (1000 miles). re torque wheel nuts to 110 N·m (11.2 kgf·m, 81 ft·lbf) D If you have changed your wheel nuts are 1600 km (1000 rotated, repaired or tires, check that the still tight after driving miles). CAUTION Observe the following instructions. Otherwise, an accident may occur resulting in death or serious injuries. D When using tire chains, be careful not to damage the aluminum wheels. D Use only Toyota wheel nuts and wrench designed for your aluminum wheels. Toyota balance weights or equivalent and a plastic or rubber hammer. D Do not use wheels other than the manufacturer's recommended size, as this may cause dangerous handling characteristics resulting in loss of control. D When balancing your wheels, use only D As with any wheel, periodically check your aluminum wheels for damage. If damaged, replace immediately. D Four−wheel drive models: Do not use brands, sizes may cause characteristics control. wheels of different and types, as this dangerous handling resulting in loss of 2007 SEQUOIA from Sep. '06 Prod. (OM34457U) 441