2007 Toyota Sequoia Owners Manual - Page 463

06 05.31 Adding washer fluid If any washer does windshield washer light comes on, the empty. Add washer not work or the low fluid level warning washer tank may be fluid. Replacing light bulbs- The following illustrations show how to gain access to the bulbs. When replacing a bulb, make sure the ignition switch and light switch are off. Use bulbs with the wattage ratings given in the table. The inside of the lens of exterior lights such as headlights may temporarily fog up when the lens becomes wet in the rain or in a car wash. This is not a problem because the fogging is caused by the temperature difference between the outside and inside of the lens, just like the windshield fogs up in the rain. However, if there is a large drop of water on the inside of the lens, or if there is water pooled inside the light, contact your Toyota dealer. You may use plain water as washer fluid. However, in cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. This product is available at your Toyota dealer and most auto parts stores. Follow the manufacturer's directions for how much to mix with water. CAUTION D To prevent burning yourself, do not replace the light bulbs while they are hot. D Halogen bulbs have pressurized gas inside and require special handling. They can burst or shatter if scratched or dropped. Hold a bulb only by its plastic or metal case. Do not touch the glass part of a bulb with bare hands. NOTICE Do not use engine antifreeze or any other substitute because it may damage your vehicle's paint. NOTICE Only use a bulb of the listed type. 448 2007 SEQUOIA from Sep. '06 Prod. (OM34457U)