2007 Toyota Sequoia Owners Manual - Page 530

07 05.22 If the battery is disconnected or run down, the back window may not operate automatically and the jam protection function will not function correctly after you reconnect, replace or recharge the battery. In any of these cases, you should normalize the back window. To normalize the back window, close the window fully by the power back window switch. If the window has already been closed, open it slightly and then fully close it using the power back window switch. Make sure that the back window opens and closes automatically. If the back window cannot be operated properly, have it checked by your Toyota dealer. OPERATING FROM OUTSIDE The back window can be opened and closed with the key operation in the back door keyhole. To open: Turn the key fully counterclockwise and hold it. After the door is unlocked, the window begins to open. To stop the window partway, release the key. To close: Turn the key fully clockwise and hold it. u12069 After the door is locked, the window begins to close. To stop the window partway, release the key. This door key linked function can be erased. For details, contact your Toyota dealer. You can also open the back window when the back window wiper is working. At the time, the wiper stops working until the window is closed again. If the back window is not fully closed, the back window wiper, washer, and defogger will not work. (See "Back window wiper and washer" on page 156 and "Back window and outside rear view mirror defoggers" on page 156 in Section 1 −5.) 2007 SEQUOIA from Aug. '07 Prod. (OM34462U) 33