2007 Toyota Sequoia Owners Manual - Page 54

06 06.01 WHEN THE SYSTEM IS SET Activating the system The system will sound the alarm under the following conditions: Reactivating the alarm Once set, the system automatically resets the alarm after the alarm stops. The alarm will activate again under the same circumstances described in "Activating the system". Stopping the alarm The alarm will be stopped by the following two ways: TESTING THE SYSTEM 1. Open all the windows. 2. Set the system as described above. The side doors and back door should be locked with the key or wireless remote control transmitter. Be sure to wait until the indicator light goes off or starts flashing. 3. Unlock any side door from the inside. The system should activate the alarm. 4. Stop the alarm as described above. 5. Repeat this operation for the other doors and hood. When testing the hood, also check that the system is activated when the battery terminal is disconnected and then reconnected. If the system does not work properly, have it checked by your Toyota dealer. D If any of the side doors is unlocked or opened without the key or wireless remote control transmitter, or if the back door or hood is forcibly opened D If the battery terminal is disconnected and then reconnected Vehicles with the glass breakage sensor- D Turn the ignition key from the "LOCK" to "ON" position. D The side windows are tapped or broken. The indicator light will come on when the system is activated. If the alarm has been activated and the key is not in the ignition switch, all the side doors and back door will re−lock automatically. After one minute, the alarm will automatically stop and the indicator light will starts flashing again. D Unlock any of the side doors or back door with the key or wireless remote control transmitter. These ways cancel the system at the same time. 38 2007 SEQUOIA from Sep. '06 Prod. (OM34457U)