2007 Toyota Sequoia Owners Manual - Page 545

07 05.22 Driving position memory system CAUTION Avoid reclining the seatback any more than needed. The seat belts provide maximum protection in a frontal or rear collision when the driver and the front passenger are sitting up straight and well back in the seats. If you are reclined, the lap belt may slide past your hips and apply restraint forces directly to the abdomen or your neck may contact the shoulder belt. In the event of a frontal collision, the more the seat is reclined, the greater the risk of death or serious injury. 3. SEAT LUMBAR ADJUSTING SWITCH SUPPORT This system can memorize the position of the driver's seat and outside rear view mirrors, and recall them at the touch of a button. Buttons "1" and "2" can memorize two separate positions. u13175 SETTING THE DRIVING POSITION The key must be in the "ON" position and the selector lever is in the "P" position. 1. Adjust the driver's seat and outside rear view mirrors to the desired position. 2. While pushing the "SET" button, push button "1" or "2" until a beep is heard. The system can memorize up to 2 positions by repeating the above steps. If step 2 is performed when both buttons "1" and "2" are memorized, the previous position will be erased and a new position will be set. Push the control switch in the desired direction. The amount of lumbar support will change while the switch is pushed. Vehicles with the driving position memory system-The position of the driver's seat and outside rear view mirrors can be memorized. For details, see "Driving position memory system" on page 48 in this Section. 48 2007 SEQUOIA from Aug. '07 Prod. (OM34462U)