2007 Toyota Sequoia Owners Manual - Page 689

07 05.22 To change "LO" mode to "HI", push the switch twice. Selecting "N" mode- To change "HI" mode to "N", push the height control switch on the "Ɲ" side once. If the underbody of the vehicle has touched the surface on bumpy roads, the vehicle height cannot be lowered with the height control switch. To change "LO" mode to "N", push the height control switch on the "Ɯ" side once. Selecting "LO" mode- Push the height control switch on the " Ɲ" side while the vehicle is stopped. To change "N" mode to "LO", push the switch once. To change "HI" mode to "LO", push the switch twice. If the underbody of the vehicle has touched the surface on bumpy roads, the vehicle height cannot be lowered with the height control switch. u16037 Even if the engine is stopped while the vehicle height is being lowered, the operation continues for up to 35 seconds. If, within this 35 seconds, any of the side doors or the back door is opened, operation will continue for a further 15 seconds. When adjusting the vehicle height with one or more doors open, make sure that there is nothing that might come into contact with the vehicle body or around the doors. (c) Vehicle height adjustment To change the mode, push the height control switch on either side of "Ɯ" (higher) or "Ɲ" (lower). The height control indicator light indicates which mode is selected. (See "(d) Indicator lights" described below.) Selecting "HI" mode- Push the height control switch on the " Ɯ" side when the vehicle speed is 30 km/h (18 mph) or less. To change "N" mode to "HI", push the switch once. 2007 SEQUOIA from Aug. '07 Prod. (OM34462U) 193