2007 Toyota Sequoia Owners Manual - Page 700

07 05.22 D If the ID code on the tire pressure warning valves and transmitters is not registered in the tire pressure warning computer. D If the tire inflation pressure is more If the tire pressure warning light continues to come on after blinking for 1 minute when the ignition key is turned to the "ON" position, have the system checked by your Toyota dealer. Even if you use genuine wheels, the tire pressure warning system may not work properly with some types of tires. Pushing the tire pressure warning reset switch should not turn off the tire pressure warning light. For vehicles sold in U.S.A. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. than 500 kPa (5.1 kgf/cm2 or bar, 73 psi). The system may be disabled in the following conditions: (When the condition becomes normal, the system will work properly.) D If the tire inflation pressure is more D If electronic devices or facilities using similar radio nearby. wave frequencies are than 500 kPa (5.1 kgf/cm2 or bar, 73 psi). D If a radio set at similar frequencies is in use in the vehicle. D If a window tint that affects the radio wave signals is installed. D If there is a lot of snow or ice on the vehicle, in particular around the wheels or wheel housings. D If non−genuine Toyota wheels are used. D If tire chains are used. D If the spare tire is in a location subject to poor radio wave signal reception. 204 2007 SEQUOIA from Aug. '07 Prod. (OM34462U)