2007 Toyota Sequoia Owners Manual - Page 702

07 05.22 D When changing the tire inflation pressure by changing traveling speed or load weight, etc. D When changing the tire size. u16051 To initialize the system, perform the following: 1. Park the vehicle in a safe place and turn the ignition key to the "ACC" or "LOCK" position. 2. Adjust the pressure of all the installed tires (including spare) to the specified cold tire inflation pressure level. (See "Tires" on page 466 in Section 8.) 3. Turn the ignition key to the "ON" position. 4. Push and hold the tire pressure warning reset switch until the tire pressure warning light blinks slowly three times. 5. Wait for a few minutes with the ignition key "ON", and then turn the ignition key to the "ACC" or "LOCK" position. If you push the tire pressure warning reset switch while vehicle is moving, initialization is not performed. If you push the tire pressure warning reset switch accidentally and initialization is performed, adjust the tire inflation pressure to the specified level and initialize the system again. TIRE PRESSURE SWITCH WARNING RESET When initializing the system, the present tire inflation pressure is stored as standard. The tire pressure warning system determines decreased air pressure by comparing the present and the standard tire inflation pressures. When you change the set tire inflation pressure, it is necessary to initialize the tire pressure warning system. D When rotating the tires on vehicles differing with front and rear tire inflation pressures. 206 2007 SEQUOIA from Aug. '07 Prod. (OM34462U)