2008 Toyota Matrix Owners Manual - Page 276

'08 MATRIX_U (L/O 0706) Checking the engine oil level NOTICE Low level Full level ENGINE OIL SELECTION "Toyota Genuine Motor Oil" is used in your Toyota vehicle. Use Toyota approved "Toyota Genuine Motor Oil" or equivalent to satisfy the following grade and viscosity. Oil grade: ILSAC multigrade engine oil Recommended viscosity: SAE 5W−30 Be careful not to drop engine oil on the vehicle components. If the oil level is below or only slightly above the low level, add engine oil of the same type as already in the engine. Remove the oil filler cap and add engine oil in small quantities at a time, checking the dipstick. We recommend that you use a funnel when adding oil. The approximate quantity of oil needed to raise the level between low and full on the dipstick is indicated as follows: 1.5 L (1.6 qt., 1.3 Imp. qt.) For the engine oil capacity, see "Service specifications" on page 305 in Section 8. When the level reaches within the correct range, install the filler cap hand−tight. Add oil O.K. Too full With the engine at operating temperature and turned off, check the oil level on the dipstick. 1. To get a correct reading, the vehicle should be on level ground. After turning off the engine, wait a few minutes for the oil to drain back into the bottom of the engine. 2. Pull the dipstick out, hold a rag under the end and wipe it clean. 3. Reinsert the dipstick-push it in as far as it will go, or the reading will not be correct. 4. Pull the dipstick out and look at the oil level while holding a rag under the end. Outside temperature NOTICE z Be careful not to spill engine oil on the vehicle components. z Avoid overfilling, or could be damaged. the engine z Check the oil level on the dipstick once again after adding the oil. 276 2008 COROLLA MATRIX from Aug. '07 Prod. (OM12B26U)