2008 Toyota Tacoma Warranty, Maitenance, Services Guide - Page 15

2008 Tacoma Scheduled Maintenance Guide MAINTENANCE LOG 60,000 Miles or 72 months Lubricate propeller shaft (4WD) Re-torque propeller shaft bolt Replace cabin air filter Replace engine air filter Replace engine oil and oil filter 1 Replace rear differential oil (Prerunner and 4WD vehicles with optional limited slip differential only) Replace spark plugs (1GR-FE engine) 5 Rotate tires Visually inspect brake linings/drums and brake pads/discs 6 Inspect the following: __ Ball joints and dust covers __ Brake lines and hoses __ Drive belts 7 __ Drive shaft boots (4WD) __ Engine coolant 3 __ Engine valve clearance 8 __ Exhaust pipes and mountings __ Front differential oil (4WD) __ Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses __ Fuel tank cap gasket __ Radiator and condenser __ Rear differential oil (except Prerunner and 4WD vehicles with optional limited slip differential) __ Steering gear box __ Steering linkage and boots __ Transfer case oil (4WD) __ Transmission fluid or oil 2 Additional Maintenance Items for Special Operating Conditions Driving on dirt roads or dusty roads: Tighten nuts and bolts on chassis Driving while towing: Replace front differential oil (4WD) Replace rear differential oil Replace transfer case oil (4WD) Replace transmission fluid or oil Tighten nuts and bolts on chassis DEALER SERVICE VERIFICATION: DATE: MILEAGE: Reset the oil replacement reminder light (ЉMAINT REQDЉ) or the message ЉOIL MAINTENANCE REQUIREDЉ on the multi-information display after engine oil replacement. Perform these service items only if you drive primarily under the conditions indicated. 3 Refer to ЉEngine CoolantЉ in the ЉExplanation of Maintenance ItemsЉ section in the back of this guide for more information. 4 Includes operating on roads which road salt has been applied. 5 Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty. 6 Inspect thickness measurement and disc runout. 7 Initial inspection at 60,000 miles/72 months. Inspect every 15,000 miles/18 months thereafter. 8 Check for tappet noise and engine vibration and adjust if necessary, 1GR-FE engine only. 2 1 13