2010 Toyota Highlander Navigation Manual - Page 193

AUDIO/VIDEO SYSTEM (b) Presetting a station 1. Tune in the desired station. 2. Touch one of the touch−screen buttons (1 - 6) you want and hold it until a beep is heard. This sets the station to the touch−screen button and the frequency appears on the touch−screen button. Each radio mode (AM, FM1 or FM2) can store up to 6 stations. To change the preset station to a different one, follow the same procedure. The preset station memory is cancelled when the power source is interrupted by 12 volt battery disconnection or a blown fuse. (c) Selecting a station Tune in the desired station using one of the following methods. Preset tuning: Touch the touch−screen button (1 - 6) for the station you want. The touch−screen button is highlighted and the station frequency appears on the screen. Seek tuning: Push the "SEEK/TRACK" button on either side. The radio will begin seeking up or down for a station of the nearest frequency and will stop on reception. Each time you push the button, the stations will be searched automatically one after another. To scan all the frequencies: Touch "SCAN" on the screen or push the "SCAN" button briefly. "SCAN" appears on the screen. The radio will find the next station and stay there for a few seconds, and then scan again. To select a station, touch "SCAN" or push the "SCAN" button again. To scan the preset stations: Touch "SCAN" on the screen or push the "SCAN" button for longer than a second. "P. SCAN" appears on the screen. The radio will tune in the next preset station, stay there for a few seconds, and then move to the next preset station. To select a station, touch "SCAN" or push the "SCAN" button again. 194