2010 Toyota Highlander Warranty, Maitenance, Services Guide - Page 53

Maintenance Log 120,000 miles or 144 months Re-torque drive shaft bolt Replace cabin air filter Replace engine air filter Replace engine oil and oil filter1 Replace spark plugs3 Rotate tires Inspect the following: Automatic transmission fluid Ball joints and dust covers Brake lines and hoses Brake linings/drums and brake pads/discs4 Drive shaft boots Engine/Inverter coolant5 Engine valve clearance6 Exhaust pipes and mountings Front differential oil Fuel lines and connections, fuel tank band and fuel tank vapor vent system hoses Fuel tank cap gasket Radiator, condenser and/or intercooler Rear differential oil Steering gear box Steering linkage and boots Additional Maintenance Items for Special Operating Conditions2 Driving on dirt roads or dusty roads: Tighten nuts and bolts on chassis and body Driving while towing: Replace automatic transmission fluid Replace front differential oil Replace rear differential oil Tighten nuts and bolts on chassis and body MAINTENANCE DEALER SERVICE VERIFICATION: DATE: MILEAGE: 1 2 3 4 5 6 Reset the oil replacement reminder light ("MAINT REQD") or the message "OIL MAINTENANCE REQUIRED" on the multi-information display after engine oil replacement. Perform these service items only if you drive primarily under the conditions indicated. Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty. Inspect thickness measurement and disc runout. Refer to "Engine/Inverter Coolant" in the "Explanation of Maintenance Items" section in the back of this guide for more information. Check for tappet noise and engine vibration and adjust if necessary. Maintenance Log 51