2010 Toyota Sequoia Navigation Manual - Page 464

09 01.08 AUDIO SYSTEM D Presetting a station D Selecting a station Tune in the desired station using one of the following methods. Preset tuning: Touch the channel selector button (1 - 6) for the station you want. The touch screen button is highlighted and the station frequency appears on the screen. Seek tuning: Push " " or " " sides of the "TUNE·SEEK/TRACK" button and hold it until you hear a beep. The radio will begin seeking up or down for a station of the nearest frequency and will stop on reception. Each time you push the button, the stations will be searched automatically one after another. To scan all the frequencies: Touch "SCAN" on the screen briefly. "SCAN" appears on the screen. The radio will find the next station and stay there for a few seconds, and then scan again. To select a station, touch "SCAN" again. To scan the preset stations: Touch "SCAN" on the screen for longer than approximately a second. "P·SCAN" appears on the screen. The radio will tune in the next preset station, stay there for a few seconds, and then move to the next preset station. To select a station, touch "SCAN" again. 6U5D75aF 1. Tune in the desired station. 2. Touch one of the channel selector buttons (1 - 6) you want and hold it until a beep is heard. This sets the station to the touch screen button and the frequency appears on the touch screen button. Each radio mode can store up to 6 stations. To change the preset station to a different one, follow the same procedure. The preset station memory is cancelled when the power source is interrupted by battery disconnection or a blown fuse. 148 2010 SEQUOIA Navigation Entry from April.09 Prod.(OM34488U)