2013 Toyota Land Cruiser Navigation Manual - Page 346

1. REAR VIEW MONITOR SYSTEM 3. THINGS YOU SHOULD KNOW IF YOU THINK SOMETHING IS WRONG If you notice any of the following symptoms, refer to the likely cause and the solution, and re-check. If the symptom is not resolved by the solution, have the vehicle inspected by your Toyota dealer. Symptom The image is difficult to see Likely cause • The vehicle is in a dark area • The temperature around the lens is either high or low • The outside temperature is low • There are water droplets on the camera • It is raining or humid • Foreign matter (mud etc.) is adhering to the camera • Sunlight or headlights are shining directly into the camera • The vehicle is under fluorescent lights, sodium lights, mercury lights etc. Dirt or foreign matter (such as water droplets, snow, mud etc.) is adhering to the camera. When a bright spot (such as sunlight reflecting off the body of another vehicle) is received by the camera, a vertical streak may be left above and below the bright spot (smear effect). Solution Back up while visually checking the vehicle's surroundings. (Use the monitor again once conditions have been improved.) The procedure for adjusting the picture quality of the rear view monitor system is the same as the procedure for adjusting the navigation screen. (See page 31.) The image is blurry Rinse the camera lens with water and wipe it clean with a soft cloth. Wash with a mild soap if the dirt is stubborn. Back up while visually checking the vehicle's surroundings. (Use the monitor again once conditions have been improved.) A vertical white streak is on the screen Bright spot The image is out of alignment The camera or surrounding area has received a strong impact. Have the vehicle inspected by your Toyota dealer. 362 L/C200 (US) NAVI 60G58U 12.01.19 11:29