2013 Toyota Sequoia Navigation Manual - Page 124

1. PHONE OPERATION 1 To hang up the phone: Touch or press the wheel. INFORMATION switch on the steering Touch or press the switch on the steering wheel to start talking with the other party. ● The continuous tone signal is the marked sign (p or w) and the number that follows the phone number. (e.g. 056133w0123p#1 ) ● When the "p" pause tone is used, after waiting 2 seconds the tone data up until the next pause tone will be automatically sent. When the "w" pause tone is used, the tone data up until the next pause tone will be automatically sent after user operation. ● This operation can be done when it is desirable to operate an answering machine or use a telephone service in a bank for example. The phone number and the code number in the phonebook can be registered. Touch or press the switch on the steering wheel to refuse the call. 4 PHONE BY VOICE RECOGNITION "Send Tones" can be operated by giving a command during a call. The operating procedure is similar to other voice recognition operations. (For the operation of voice recognition, see "VOICE COMMAND SYSTEM" on page 238.) Each time is touched or the switch on the steering wheel is pressed during an interrupted call, the party who is on hold will be switched. INFORMATION INCOMING CALL WAITING When a call is interrupted by a third party while talking, this screen is displayed. ● If your cellular phone does not support HFP Ver. 1.5, this function cannot be used. ● The ring tone that has been set in the "Sound Settings" screen sounds when there is an incoming call. Depending on the type of Bluetooth® phone, both the navigation system and Bluetooth® phone may sound simultaneously when there is an incoming call. (See "RING TONE SETTING" on page 138.) 133