2013 Toyota Venza Navigation Manual - Page 130

1. PHONE OPERATION CONNECTING A Bluetooth® PHONE AUTOMATICALLY When a phone is registered, auto connection is turned on. Always set it to this mode and leave the Bluetooth® phone in a location where connection can be established. Vehicles with a smart key system When the "ENGINE START STOP" switch is in ACCESSORY or IGNITION ON mode, the system searches for a nearby registered cellular phone. The system will connect with the phone that was last connected, if it is nearby. When "Display Phone Status" is set to "On", the connection status is displayed. (See "Bluetooth® DEVICE CONNECTION STATUS DISPLAY SETTINGS" on page 188.) This screen appears when the Bluetooth® phone is first connected after the "ENGINE START STOP" switch is in ACCESSORY or IGNITION ON mode. Vehicles without a smart key system When the engine switch is in the "ACC" or "ON" position, the system searches for a nearby registered cellular phone. The system will connect with the phone that was last connected, if it is nearby. When "Display Phone Status" is set to "On", the connection status is displayed. (See "Bluetooth® DEVICE CONNECTION STATUS DISPLAY SETTINGS" on page 188.) This screen appears when the Bluetooth® phone is first connected after the engine switch is in the "ACC" or "ON" position. INFORMATION 4 PHONE For automatic connection, see "CHANGING "Bluetooth* Power"" on page 186. *: Bluetooth is a registered trademark of Bluetooth SIG, Inc. ● It may take time if the phone connection is carried out during Bluetooth® device playback. Depending on the type of Bluetooth® phone being connected, it may be necessary to perform additional steps on the phone. 139 VENZA (US) NAVI 73011U 12.03.01 09:40