3Com 3C13750-US Release Notes

3Com 3C13750-US - Router 5231 Chassis 3 Modularslot 2 10/100TX Fe Manual

3Com 3C13750-US manual content summary:

  • 3Com 3C13750-US | Release Notes - Page 1
    Router 3000/5000 Series Release Notes for V1.10 http://www.3com.com/ Part No. 10014223 Published October 2003
  • 3Com 3C13750-US | Release Notes - Page 2
    Contents Chapter 1 Introduction ...3 1.1. Scope ...3 1.2. Cable Connections ...3 1.3. Online Resources...3 Chapter 2 Release Notes for the Router 3000 and Router 5000 Series V1.10 4 2.1. System Access...4 2.2. System Management ...4 2.3. Interface Management ...5 2.4. Link Layer Protocol...5 2.5.
  • 3Com 3C13750-US | Release Notes - Page 3
    are provided on the Service and Warranty pages of the 3Com support website http://support.3com.com . See the Router 3000 Installation Guide or Router 5000 Installation Guide for software download instructions. Download the Router 3000 Installation Guide from: http://support.3com.com/infodeli/tools
  • 3Com 3C13750-US | Release Notes - Page 4
    Matrix DS table has src and dst addresses reversed. Routers are not recognized by Network Management applications, such as 3Com Network Supervisor, unless SNMP V1 is enabled. Solution Save the device, as described in the Installation Guide, and then discover the network using Network Supervisor.
  • 3Com 3C13750-US | Release Notes - Page 5
    been renamed. Router 3000 series routers do not autonegotiate with the 3Com SSII Dual Speed Hub 500. Routers only support switch type dss1 BRI S/T (European ISDN). Solution If the frame relay peer is set to LMI, set the Local Interface to Non-Standard. Adjust the speed and duplex manually on both
  • 3Com 3C13750-US | Release Notes - Page 6
    , you must configure OSPF peer ipaddress. Set the OSPF cost for the DTE manually. To configure different policies for one peer, place that peer in a separate router has returned to service. Poison Reverse is not supported in this release. 2.7. Multicast Protocol Symptom The router does not support
  • 3Com 3C13750-US | Release Notes - Page 7
    cannot be classified for QoS. Solution Use Layer 3 prioritization. 2.11. Dial-Up Symptom The ppp chap user command is not supported in dialer interfaces. Solution When using Resource DCC and using chap authentication, ppp chap user should be configured only on the router that is dialing out. 7
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7

Router 3000/5000
Series
Release Notes for V1.10
Part No.
10014223
Published October 2003