Acer AM501 AM501 User Guide

Acer AM501 Manual

Get Acer AM501 PDF manuals and user guides View all Acer AM501 manuals
Add to My Manuals
Save this manual to your list of manuals

Acer AM501 manual content summary:

  • Acer AM501 | AM501 User Guide - Page 1
    TABLE OF CONTENTS TABLE OF CONTENTS 1 IMPORTANT SAFETY INSTRUCTIONS 2 FEDERAL COMMUNICATIONS COMMISSION 3 CONNECTING THE MONITOR AND SWIVEL BASE 4 REMOVING THE MONITOR AND SWIVEL BASE 4 INTRODUCTION 5 INSTALLATION 6 USER CONTROLS 7 LED ICON SUMMARY 9 SPECIFICATIONS 10 TROUBLESHOOTING 11 1
  • Acer AM501 | AM501 User Guide - Page 2
    IMPORTANT SAFETY INSTRUCTIONS 1. Please read these instructions thoroughly. 2. Please keep this guide for future use. 3. occur, the device must be disconnected from the main supply, and be checked by a qualified service center: • Power cable or power plug are damaged; • Liquid has entered the device;
  • Acer AM501 | AM501 User Guide - Page 3
    and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is connect I/O devices to this equipment. CANADIAN DOC NOTICE For Class B Computing Devices This Class B digital apparatus meets all requirements of the Canadian
  • Acer AM501 | AM501 User Guide - Page 4
    CONNECTING THE MONITOR AND SWIVEL BASE 1. Place the monitor with its tube down on a stable surface. 2. Align the four tabs of the swivel base with the slots in the bottom of the monitor. 3. Insert the tabs into the slots of the monitor 4. Now slowly slide the swivel base toward the front of the
  • Acer AM501 | AM501 User Guide - Page 5
    high performance 15˝ Monitor. Using state-of-the-art electronics, this monitor supports a 1024 X 768 resolution. The on-screen display allows you to customize and Swivel Base This User's Manual Please contact your dealer or nearest service centers if any of the above items is missing or damaged. 5
  • Acer AM501 | AM501 User Guide - Page 6
    , then plug the other end into an electrical outlet that is easily accessible, and close to the monitor. 3. First turn on the power of the computer, then that of the monitor. 4. Adjust the tilt of the swivel base for maximum viewing comfort. The installation of your monitor is now complete. 6
  • Acer AM501 | AM501 User Guide - Page 7
    USER CONTROLS 1 Power Switch Turns the monitor on and off 2 Power LED Indicator Green States Light Flash Status On Sleep 7
  • Acer AM501 | AM501 User Guide - Page 8
    3 Reset Resets default values. 4 Adjustments For adjusting the display in the selected function. 5 Select button For selecting functions. 6 Function LED Indicator 1) When the highest or lowest possible setting for a particular display control has been reached, its corresponding LED will flash.
  • Acer AM501 | AM501 User Guide - Page 9
    LED ICON SUMMARY Icon Function Brightness Contrast H. Size H. Position V. Size V. Position Pincushion Trapezoid Function Description Adjusts display brightness Adjusts display contrast Increases and decreases screen width Shifts display image right or left Increase and decrease screen height
  • Acer AM501 | AM501 User Guide - Page 10
    SPECIFICATIONS Screen Size Dot Pitch (mm) Surface Viewable Image Area (mm) Input Signal Video Sync. Scanning Frequency Horizontal (KHz) Vertical (Hz) Max Resolution Signal Cable Power Consumption Power Supply Power Management Display Modes Preset By User Operating Operating Temperature Relative
  • Acer AM501 | AM501 User Guide - Page 11
    TROUBLESHOOTING Please refer to the following solutions for the failure symptoms that occur the most frequent. If the symptom remains after trying these suggested solutions, please contact your local authorized service center. Problem Problem: No display appears on screen. Make sure that the computer
  • Acer AM501 | AM501 User Guide - Page 12
    12
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
1
TABLE OF CONTENTS
TABLE OF CONTENTS
...........................................................................
1
IMPORTANT SAFETY INSTRUCTIONS
.................................................
2
FEDERAL COMMUNICATIONS COMMISSION
......................................
3
CONNECTING THE MONITOR AND SWIVEL BASE
.............................
4
REMOVING THE MONITOR AND SWIVEL BASE
..................................
4
INTRODUCTION
.......................................................................................
5
INSTALLATION
........................................................................................
6
USER CONTROLS
...................................................................................
7
LED ICON SUMMARY
.............................................................................
9
SPECIFICATIONS
..................................................................................
10
TROUBLESHOOTING
............................................................................
11