Acer Aspire 2930 Aspire 2930 / 2930Z / 2430 Service Guide - Page 35

Main The Main screen allows the user to set the system time and date as well as enable and disable boot option and recovery. Information Main System Time System Date Total Memory Video Memory InsydeH20 Setup Utility Advanced Security Power Boot [13:04:04] [06/04/2008] 4095 MB [32MB] Rev. 3.5 Exit Item Specific Help This is the help for the hour field. Valid range is from 0 to 23. INCREASE/REDUCE : F5/F6 Quick Boot Network Boot F12 Boot Menu D2D Recovery SATA Mode [Enabled] [Enabled] [Disabled] [Enabled] [AHCI] F1 Help ESC Exit ↑↓ Select Item ←→ Select Menu F5/F6 Change Values F9 Setup Default Enter SelectXSubMenu F10 Save and Exit NOTE: The screen above is for your reference only. Actual values may differ. The table below describes the parameters in this screen. Settings in boldface are the default and suggested parameter settings. Parameter Description Format/Option System Time Sets the system time. The hours are displayed with 24- Format: HH:MM:SS hour format. (hour:minute:second) System Date Sets the system date. Format MM/DD/YYYY (month/day/year) Total Memory This field reports the memory size of the system. N/A Memory size is fixed to 3017 MB. Video Memory Shows the video memory size. VGA Memory size=32 MB N/A Quick Boot Allows startup to skip certain tests while booting, decreasing the time needed to boot the system. Option: Enabled or Disabled Network Boot Enables, disables the system boot from LAN (remote server). Option: Enabled or Disabled F12 Boot Menu Enables, disables Boot Menu during POST. Option: Disabled or Enabled D2D Recovery Enables, disables D2D Recovery function. The function allows the user to create a hidden partition on hard disc drive to store operation system and restore the system to factory defaults. Option: Enabled or Disabled SATA Mode Control the mode in which the SATA controller should operate. Option: AHCI Mode or IDE Mode NOTE: The sub-items under each device will not be shown if the device control is set to disable or auto. This is because the user is not allowed to control the settings in these cases. Chapter 2 25