Acer Aspire 5515 Acer Aspire 5515 Notebook Service Guide - Page 36

Parameter PS/2 Mouse Description Enable or Disable PS/2 Mouse port IRQ12. IDE Controller On Chip SATA SATA Mode SATA Smbus Interface USB Host Controller Legacy USB Support Option ROM Placement Gigabit Lan Network Boot Large Disk Access Mode Installed O/S Reset Configuration Data Processor Assisted Virtualization Configure the Integrated Local Bus IDE Controller. Enable On chip SATA. Select the SATA Mode. Enable or disable the SATA Smbus Interface. Enable or disable USB hardware. Enable support for Legacy Universal Serial Bus. Determines which peripheral devices can be booted. NOTE: Changes to this setting can cause the system to halt during boot. Enable or disable the on board Gigabit LAN. Enable to support LAN on mainboard boot or disable for faster stand alone boot. Set the Large Disk Access mode. Different O/S require different drive geometry representations. Select Other for UNIX, Novell NetWare, or other O/S. Set the most commonly used O/S on the system. Clear Extended System Configuration Data (ESCD) area. Enable the hardware visualization support. Submenu Items Option: Enabled, Auto Detect, or Disabled Option: Disabled or Enabled Option: Enabled or Disabled Option: IDE-ACHI or IDE Native Option: Enabled or Disabled Option: Enabled or Disabled Option: Enabled or Disabled Option: Disabled, Temporary, or E000 Extend Option: Enabled or Disabled Option: Enabled or Disabled Option: DOS or Other Option: Other, Win2000, WinMe, Win98, or Win95 Option: No or Yes Option: Enabled or Disabled Chapter 2 25