Acer Aspire 8930G Aspire 8930G Service Guide - Page 78

Error Message List, Run Load Default Settings in BIOS Setup - operating disk

Page 78 highlights

Error Messages Invalid System Configuration Data I/O device IRQ conflict Operating system not found FRU/Action in Sequence BIOS ROM System board Run "Load Default Settings" in BIOS Setup Utility. RTC battery System board Enter Setup and see if fixed disk and drive A: are properly identified. Diskette drive Hard disk drive System board Error Message List No beep Error Messages No beep, power-on indicator turns off and LCD is blank. No beep, power-on indicator turns on and LCD is blank. No beep, power-on indicator turns on and LCD is blank. But you can see POST on an external CRT. No beep, power-on indicator turns on and a blinking cursor shown on LCD during POST. No beep during POST but system runs correctly. FRU/Action in Sequence Power source (battery pack and power adapter). See "Power System Check" on page 67. Ensure every connector is connected tightly and correctly. Reconnect the DIMM. LED board. System board. Power source (battery pack and power adapter). See "Power System Check" on page 67. Reconnect the LCD connector Hard disk drive LCD inverter ID LCD cable LCD Inverter LCD System board Reconnect the LCD connectors. LCD inverter ID LCD cable LCD inverter LCD System board Ensure every connector is connected tightly and correctly. System board Speaker System board 72 Chapter 4

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.