Acer Ferrari 1000 Ferrari 1000 Service Guide - Page 97
Load Default Settings, Power System Check, Error Message, FRU/Action in Sequence
View all Acer Ferrari 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Error Message Invalid System Configuration Data I/O device IRQ conflict Operating system not found No beep, power-on indicator turns off and LCD is blank. No beep, power-on indicator turns on and LCD is blank. No beep, power-on indicator turns on and LCD is blank. But you can see POST on an external CRT. No beep, power-on indicator turns on and a blinking cursor shown on LCD during POST. No beep during POST but system runs correctly. FRU/Action in Sequence BIOS ROM System board Run Load Default Settings in BIOS Setup Utility. RTC battery System board Enter Setup and see if fixed disk and drive A: are properly identified. Diskette drive Hard disk drive System board Power source (battery pack and power adapter). See Power System Check. Ensure every connector is connected correctly. Reconnect the DIMM. LED board System board Power source (battery pack and power adapter). See Power System Check. Reconnect the LCD connector. Hard disk drive LCD inverter ID LCD cable LCD Inverter LCD System board Reconnect the LCD connectors. LCD inverter ID LCD cable LCD inverter LCD System board Ensure every connector is connected tightly and correctly. System board Speaker System board 87 Chapter 4