Acer H6510BD Acer Projector H6510BD, P1340W, X1140, X1240 Service Guide - Page 96

Exposed Metal 2 Exposed Metal 2 is due to a shift in positioning of either the die or the window aperture, which may allow light to be reflected off of the layer of metal 2 that is below the super structure (mirrors). This defect is located outside of the POM. Reflective Edge Reflective Edge is light that may reflect from the edge of the DMD window aperture onto the projection screen. It will appear as a thin diffuse line outside of the POM. Blue 60 Screen The Blue 60 screen is used to test for major dark blemishes. All areas of the screen are colored a Microsoft Paintbrush blue 60 (green and red set at 0, blue set at 60). NOTE: If linear degamma is not used then the Microsoft Paintbrush values must be adjusted to match the degamma table being used in order to generate an equivalent blue level on the test screen image. Gray 10 Screen The Gray 10 screen is used to test for major light blemishes. All areas of the screen are colored a Microsoft Paintbrush gray 10 (green, red, and blue set at 10). NOTE: If linear degamma is not used then the Microsoft Paintbrush values must be adjusted to match the degamma table being used in order to generate an equivalent gray level on the test screen image. Gray 30 Screen The Gray 30 screen is used to test for the reset boundary artifact. All areas of the screen are colored a Microsoft Paintbrush gray 30 (green, red, and blue set at 30). NOTE: If linear degamma is not used then the Microsoft Paintbrush values must be adjusted to match the degamma table being used in order to generate an equivalent gray level on the test screen image. 3. ACCEPTANCE REQUIREMENTS Conditions of Acceptance All DMD image quality defects must be determined under the following projected image test conditions: a. Test Set degamma shall be linear. b. Test Set brightness and contrast settings shall be set to nominal. c. The diagonal size of the projected image shall be a minimum of 60 inches. d. The projection screen shall be 1X gain. e. The projected image shall be inspected from an 8 feet minimum viewing distance. f. The image shall be in focus during all Table 1 tests. 96