Acer PD100 PD100 and PD120 Service Guide - Page 53

Main Procedure No Symptom 1 No Power 2 Auto Shut Down 3 No Image 4 No Light On 5 Mechanical Noise 6 Line Bar / Line Defect 7 Image Flicker 8 Color Abnormal 47 Procedure - Ensure the Power Cord and AC Power Outlet are securely connected - Check Lamp Cover and Interrupt Switch - Ensure all connectors are securely connected and aren't broken - Check DC-DC - Check Ballast - Check Main Board - Check LED Status a. Lamp LED Light - Check Lamp - Check Lamp Driver - Check Main Board b. Temp LED Light - Check Thermal Sensor - Check Thermal Switch - Check Fan c. Color Wheel - Check Color Wheel - Check Photo Sensor d. No Power - Refer to "No Power" troubleshooting - Ensure the Signal Cable and Source work as well (If you connect multiple sources at the same time, use the "Source" button on the control panel to swtich) - Ensure all connectors are securely connected and aren't broken - Check Main Board - Check DMD Board - Check Color Wheel - Check DMD Chip - Check Engine Module - Ensure all connectors are securely connected and aren't broken - Check Lamp Module - Check DC-DC - Check Ballast - Check Main Board - Check Color Wheel - Check Fan Module - Sometimes it's because of the DMD Chip and the DMD Board did not assemble properly - Check DMD Board - Check DMD Chip - Check Main Board - Do "Reset" of the OSD Menu - Ensure the Signal Cable and Source work as well - Check Lamp Module - Check Color Wheel - Check DMD Board - Check Main Board - Do "Reset" of the OSD Menu - Adjust Color Wheel Index - Check Main Board - Check DMD Board - Check Color Wheel Chapter 4