Acer TravelMate 8210 TravelMate 8210 Service Guide - Page 87

Error Message, FRU/Action in Sequence, Run Load Default Settings in BIOS Setup Utility.

Page 87 highlights

Error Message I/O device IRQ conflict Operating system not found No beep, power-on indicator turns off and LCD is blank. No beep, power-on indicator turns on and LCD is blank. No beep, power-on indicator turns on and LCD is blank. But you can see POST on an external CRT. No beep, power-on indicator turns on and a blinking cursor shown on LCD during POST. No beep during POST but system runs correctly. FRU/Action in Sequence Run "Load Default Settings" in BIOS Setup Utility. RTC battery System board Enter Setup and see if fixed disk and drive A: are properly identified. Diskette drive Hard disk drive System board Power source (battery pack and power adapter). See "Power System Check". Ensure every connector is connected correctly. Reconnect the DIMM. LED board System board Power source (battery pack and power adapter). See "Power System Check". Reconnect the LCD connector. Hard disk drive LCD inverter ID LCD cable LCD Inverter LCD System board Reconnect the LCD connectors. LCD inverter ID LCD cable LCD inverter LCD System board Ensure every connector is connected tightly and correctly. System board Speaker System board Chapter 4 77

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.