Acer V193W User Manual
Acer V193W - bm - 19" LCD Monitor Manual
 |
UPC - 884483086146
View all Acer V193W manuals
Add to My Manuals
Save this manual to your list of manuals |
Acer V193W manual content summary:
- Acer V193W | User Manual - Page 1
Acer LCD Monitor User's Guide - Acer V193W | User Manual - Page 2
. All Rights Reserved. Acer LCD Monitor User's Guide Original Issue: 11/2007 Changes may be made periodically to the information in this publication without obligation to notify any person of such revisions or changes. Such changes will be incorporated in new editions of this manual or supplementary - Acer V193W | User Manual - Page 3
with the LCD monitor and do not indicate a problem. • Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the power switch and then turn it on again to make sure the flicker disappears. • You may find slightly uneven brightness on the screen depending on - Acer V193W | User Manual - Page 4
instructions. • Gradually increase the volume until you can hear it clearly and comfortably and without distortion. • After setting the volume level, do not increase it after your ears have adjusted • Do not place this product on an unstable cart, stand or table. If the product falls, it could be - Acer V193W | User Manual - Page 5
power cord set, make sure that the new power cord meets the following requirements: detachable type, UL listed/CSA certified, type SPT-2, rated 7 A 125 V minimum, VDE approved or its equivalent, 4.6 meters (15 feet) maximum length. Product servicing Do not attempt to service this product yourself - Acer V193W | User Manual - Page 6
the operating instructions, since improper adjustment of other . Switch off the device near gas pumps at service stations. Observe restrictions on the use of radio equipment IT Equipment Recycling Information Acer is strongly committed to environmental protection and views recycling, in the form - Acer V193W | User Manual - Page 7
acer.com/about/sustainability.htm Mercury advisory For projectors or electronic products containing an LCD/CRT monitor specific disposal information, check www.lamprecycle.org. LCD pixel statement The LCD by meeting strict energy efficiency guidelines set by the US Environmental Protection Agency - Acer V193W | User Manual - Page 8
Acer LCD monitor with an ENERGY STAR logo. This product has been shipped enabled for power management: • Activate display's Sleep mode within 15 minutes of user Finding your comfort zone Find your comfort zone by adjusting the viewing angle of the monitor, using a footrest, or raising your sitting - Acer V193W | User Manual - Page 9
visor, such as a piece of cardboard extended from the display's top front edge • Avoid adjusting your display to an awkward viewing angle. • Avoid looking at bright light sources, such as open windows, for extended periods of time. Developing good work habits Develop the following work habits to - Acer V193W | User Manual - Page 10
Shanghai, China Contact Person: Mr. Easy Lai Tel: 886-2-8691-3089 Fax: 886-2-8691-3000 E-mail: [email protected] Hereby declare that: Product: LCD Monitor Trade Name: Acer Model Number: V193W SKU Number: V193Wxxxx The first x shows the front frame's ID and color. The second x shows pedestal's ID - Acer V193W | User Manual - Page 11
responsible for this declaration: Product name: 19" LCD Monitor Model number: V193W SKU number: Name of responsible party: the others.;ADSP. Acer America Corporation Address of responsible party: 333 West San Carlos St. San Jose, CA 95110 USA Contact person: Acer Representative Tel: 1-254 - Acer V193W | User Manual - Page 12
xii - Acer V193W | User Manual - Page 13
Attaching/removing the base Screen position adjustment Connecting the power cord Power saving Display Data Channel (DDC) Connector pin assignment Standard timing table Installation User controls How to adjust a setting Acer eColor Management User Troubleshooting VGA mode DVI mode 1 iii iii - Acer V193W | User Manual - Page 14
2 - Acer V193W | User Manual - Page 15
that the following items are present when you unpack the box, and save the packing materials in case you need to ship or transport the monitor in the future. LCD monitor User's guide Quick start guide D-sub cable DVI cable (only dualinput models) AC power cord Audio Cable (Option) - Acer V193W | User Manual - Page 16
with the corresponding slots on the bottom of the base. Removing: Press the release button as indicated, then pull in the direction of the arrow to remove the base. Screen position adjustment To optimize the viewing position, you can adjust the monitor tilt by using both of your hands to hold - Acer V193W | User Manual - Page 17
or 220/240 V AC voltage area. No user-adjustment is required. • Plug one end of the power cord to the AC inlet, and plug the other end into an AC outlet. • For units using 120 V AC: Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V. • For units using 220/240 - Acer V193W | User Manual - Page 18
Connector pin assignment 1 5 6 10 11 15 15-pin color display signal cable PIN No. Description 1 Red 2 Green 3 Blue 4 Monitor ground 5 DDC-return 6 R-ground 7 G-ground 8 B-ground PIN No. Description 9 +5 V 10 Logic ground 11 Monitor ground 12 DDC-serial data 13 H-sync 14 V-sync 15 DDC-serial - Acer V193W | User Manual - Page 19
5 English 24-pin color display signal cable PIN No. Description 1 TMDS data 2- 2 TMDS data 2+ 3 TMDS data 2/4 shield 4 NC 5 hsync.vsync) 16 Hot-plug detection 17 TMDS data 0- 18 TMDS data 0+ 19 TMDS data 0/5 shield 20 NC 21 NC 22 TMDS clock shield 23 TMDS clock+ 24 DDC TMDS clock- - Acer V193W | User Manual - Page 20
6 Standard timing table English Mode Resolution 1 Acer 648x500 58 Hz 1280x800 60 Hz 2 VGA 640x480 60 Hz 640x480 72 Hz 640x480 75 Hz 3 MAC 640x480 66.66 Hz 4 VESA 720x400 70 Hz 5 SVGA 800x600 56 Hz 800x600 60 Hz 800x600 72 Hz 800x600 75 Hz 6 MAC - Acer V193W | User Manual - Page 21
cord to the monitor, then to a properly grounded AC outlet. 3 Turn on the monitor and computer Turn on the monitor first, then the computer. This sequence is very important. 4 If the monitor does not function properly, please refer to the troubleshooting section to diagnose the problem. DVI D-Sub - Acer V193W | User Manual - Page 22
the exit key (exit OSD menu). b. When the OSD menu is inactive, press this button for two seconds to activate the Auto Adjustment function. The Auto Adjustment function is used to set the HPos, VPos, Clock and Focus. 7 / Exit: a. When the OSD menu is active, this button will act as the exit key - Acer V193W | User Manual - Page 23
exit function. If you want to adjust any other function, repeat steps 2 to 4. A. Acer eColor Management: If "Acer eColor Management" is selected, the Acer eColor Management OSD will appear. B. User: If "User" is selected, the standard OSD will appear. I. Only analog-input mode II. Only digital - Acer V193W | User Manual - Page 24
the mode and run Auto Adjust. • Features and benefits Main menu icon Sub menu item User mode Text mode Standard mode Graphic mode Movie mode Description User-defined. Settings can be fine-tuned to suit any situation. Optimal balance of brightness and contrast to prevent eyestrain. The - Acer V193W | User Manual - Page 25
English 11 User Main Sub menu menu icon icon Sub menu item Contrast Brightness Description Adjusts the contrast between the foreground and background of the screen image. Adjusts the background brightness of the screen image. ACM ACM (Adaptive Contrast Management) ACM On/Off switch, default - Acer V193W | User Manual - Page 26
input signal from digital (DVI) input models) (only dual-input models). N/A DDC/CI Turns on/off DDC/CI support N/A Information Shows the resolution, H/V frequency, input port and serial number for current input. N/A Reset Clears Auto-configuration changes . N/A Exit Saves user changes - Acer V193W | User Manual - Page 27
sending your LCD monitor for servicing, please check the troubleshooting list below to see if you can self-diagnose the problem. VGA mode Problem No picture visible LED status Blue Off Remedy Using the OSD, adjust brightness and contrast to maximum or reset to their default settings. Check the - Acer V193W | User Manual - Page 28
English 14 DVI mode Problem No picture visible LED status Blue Off Remedy Using the OSD, adjust brightness and contrast to maximum or reset to their default settings. Check the power switch. Amber Check if the AC power cord is properly connected to the monitor. Check if the video signal cable
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
Acer LCD Monitor
User's Guide