Acer Veriton 5200D Veriton 5200D Service Guide - Page 48

The following table describes the parameters found in this menu . Parameter Power Management (Function Enabled in APM Mode) Suspend Mode (Function Enabled in APM Mode) HDD Power Down (Function Enabled in APM Mode) Description This function allows you to set the default parameters for power-saving modes. Set it to Disable to turn off the power management function. Set it to User Define to choose your own parameters. See the Power Management Mode Table. This item lets you set the period of time after which the system enters into Suspend mode. The Suspend mode can be Power On Suspend or Suspend to Hard Drive, and it is selected in the "Suspend Mode Option". This option lets you specify the IDE HDD idle time before the device enters the power down state. This item is independent from the power states previously described in this section (Standby and Suspend). Options User Define Max Saving Min Saving Disabled Disabled, 1 min., 2 min., 4 min., 8 min., 12 min., 20 min., 30 min., 40 min., and 1 Hour Disabled 1 min 15 min Soft-Off by PWR-BTTN (Function Enabled in ACPI and APM Mode) Wake-Up by PCI Card (Function Enabled in ACPI and APM Mode) Power-On by Ring (Function Enabled in ACPI and APM Mode) USB KB Wake-up from S3 (Function Enabled in ACPI mode) PWRON After PWR-Fail (Function Enabled in ACPI and APM Mode) Resume by Alarm (Function Enabled in ACPI and APM Mode) This is a specification of ACPI and supported by hardware. When Delay 4 sec. is selected, the soft power switch on the front panel can be used to control power On, Suspend and Off. If the switch is pressed less than 4 sec. during power On, the system will go into Suspend mode. If the switch is pressed longer than 4 sec, the system will be turned Off. The other setting is Instant-Off, where the soft power switch is only used to control On and Off, there is no need to press 4 sec, and there is no Suspend. Use PCI PME# Wake-Up system . PCI must meet PCI 2.2 specification. Delay 4 sec. Instant-Off Disabled Enabled When Enabled, any fax/ modem activity wakes Disabled up the system from suspend mode. Enabled When enabled, any USB keyboard activity wakes up the system from S3 (STR, Suspend to RAM) mode. Enabled Disabled Use this option to determine the manner by which the system will power on after a power failure. Former-Sts On Off Former Sts (former status) - System would return to its former running state prior to the power failure. On - System would be on full on state upon resuming from power failure. Off - System would remain off. Use this option to set the date and time for your Disabled computer to boot up. Enabled Date (of month) Alarm* - Indicate month when * Set Resume by Alarm to e system will boot up. Set it to 0 if you want to Enabled, then press to boot everyday. show the range of Date and Time Time (hh:mm:ss) Alarm* - Indicate the hour, Alarm. minute and second when system will boot up. NOTE: In ACPI mode: Valid-S5 and S4. In APM mode: Valid- shutdown 39 Chapter 2