Acer Veriton 5800 Veriton 5800/6800/7800 Service Guide (Gigabyte MB) - Page 83

Error Symptom Diskette drive read/write error. 1. 2. 3. 4. 1. 2. 3. 4. 1. 2. 3. 4. 5. 1. 2. 3. 4. Diskette. Diskette drive cable. Diskette drive. Main board. Action/FRU Diskette drive LED comes on for more than 2 minutes when reading data. Diskette Diskette drive connection/cable Diskette drive Main board Diskette Diskette drive power Diskette drive connection/cable Diskette drive Main board Diskette Diskette drive Diskette drive cable Main board Diskette drive LED fails to light, and the drive is unable to access for more than 2 minutes. Diskette drive test failed. Hard Disk Drive NOTE: Ensure hard disk drive is configured correctly in BIOS Setup, cable/jumper are set correctly before diagnosing any hard disk drive problems. (If only one drive is installed, please make sure the drive is connected to master connector or the drive is set to master.) Hard disk drive test failed. 1. 2. 3. 4. 1. 2. 3. 4. Enter BIOS Setup and Load default settings. Hard disk drive cable. Hard disk drive. Main board. Enter BIOS Setup and Load default settings. Hard disk drive cable. Hard disk drive. Main board. Hard disk drive cannot format completely. Hard disk drive has write error. Hard disk drive LED fails to light, but system operates normally. 1. Enter BIOS Setup and Load default settings. 2. Hard disk drive. 1. With the system power on, measure the voltage of hard disk LED connector. 2. Hard drive LED cable. CD/DVD-ROM Drive NOTE: Ensure CD/DVD-ROM drive is configured correctly in BIOS Setup, cable/jumper are set correctly and its laser beam is clean before diagnosing any CD/DVD-ROM drive problems. CD/DVD-ROM drive LED doesn't come on but works normally. CD/DVD-ROM drive LED flashes for more than 30 seconds before LED shutting off. Software asks to reinstall disc. Software displays a reading CD/DVD error. CD/DVD-ROM drive cannot load or eject when the system is turned on and its eject button is pressed and held. 1. Disconnect all cables from CD/DVD-ROM drive except power cable, then press eject button to try to unload the disk. 2. CD/DVD-ROM drive power. 3. CD/DVD-ROM drive 1. CD/DVD-ROM drive 1. CD/DVD-ROM may have dirt or foreign material on it. Check with a known good disc. 2. CD/DVD-ROM is not inserted properly. 3. CD/DVD-ROM is damaged. Chapter 4 82