Acer Veriton S480G Service Guide - Page 90

1-4: Create SATA RAID 0+1 Step 1: Shut down the EUT, unplug the power cable,connect four SATA HDDS to EUT , check the EUT all devices are connect/plug ok Step 2: Press "PWR-BTTN" to power on the EUT,Load BIOS default setting . Step 3: At "Integrated_Peripherals" page "OnChip SATA Type" item set is as "RAID" mode,save and exit. Step 4: During BIOS post, press to enter into Intel RAID setup utility. Step 5: Select "1" to enter create RAID mode ,if there is no enough avalable space (there was exist a Raid , delete it ). Step 6: Create RAID 0+1 Mode,firstly create RAID 0 Mode,enter the RAID name,such as "MyRaid0+1",default is"Volume0". Step 7: Select "RAID0(Stripe)" at "RAID Level". Step 8: Select two HDDs in "Disk" by space key. Step 9: Picture8 Press "Enter" to finish HDD selection and it will back to RAID creation interface. Step 10: Repeat RAID1 creation step and exit,then install OS.