Home » Acer Manuals » Desktops » Acer Veriton X2610 » Manual Viewer

Acer Veriton X2610 Acer Veriton X2610 Desktop Service Guide - Page 63

Remove the two screws that secure the I/O&USB board to the bracket.

Add to My Manuals
Save this manual to your list of manuals

Page 63 highlights

4. Remove the front I/O&USB board. a. Remove the two screws that secure the I/O&USB board to the bracket. b. Pull the I/O&USB board out of the bracket. Note:Circuit boards >10 cm² has been highlighted with the yellow rectangle as above image shows. Please detach the Circuit boards and follow local regulations for disposal. Chapter 3 55

Section	Page
Veriton X2610/X2610G/X2618G/X2619G Service Guide	1
Revision History	2
Copyright	3
Disclaimer	4
Conventions	5
Table of Contents	7
System Tour	9
Features	9
Block Diagram	14
System Components	15
Front Panel	15
Rear Panel	16
Hardware Specifications and Configurations	17
Power Management Function(ACPI support function)	20
System Utilities	21
CMOS Setup Utility	21
Entering CMOS setup	22
Navigating Through the Setup Utility	22
Main	23
Advanced	24
Power	30
Security	31
Boot Options	33
Exit	34
System Disassembly and Assembly	35
Disassembly Requirements	35
Pre-disassembly Procedure	36
Removing the Side Panel	37
Removing the Front Bezel	38
Removing the Heat Sink Fan Assembly	39
Removing the Processor	41
Removing the Wireless LAN Card	43
Removing the VGA Card	44
Removing the Memory Modules	45
Removing the Optical Drive	46
Removing the Hard Disk Drive	47
Removing the Power Supply	50
Removing the Internal Speaker	52
Removing the Mainboard	54
Removing the TPM Module Card	57
Removing the Intrusion Alarm Cable Assemby	58
Removing the Power Switch,OBR and LED Cable Assembly	59
Removing the Front I/O and Card Reader Boards	61
Assembly Requirements	64
Assembly Procedure	65
Install the Processor	66
Install the Heat Sink Fan Assembly	67
Install the Memory	68
Install the TPM Module Card	69
Removing the Side Panel	70
Remove the Front Bezel and the ODD Bracket	71
Install the Power Supply	72
Install the I/O Shielding	73
Install the Main Board	74
Install the Internal Speaker	75
Connect the Cable	76
Install the Optica Drive Bracket	78
Install the Hard Disk Drive	79
Install the Optica Drive	81
Install the VGA Card	83
Install the Wireless LAN Card	84
Install the Front Bezel	85
Install the Side Panel	86
System Troubleshooting	87
Hardware Diagnostic Procedure	87
System Check Procedures	88
Power System Check	88
System External Inspection	88
System Internal Inspection	88
Beep Codes	89
Checkpoints	90
Viewing BIOS checkpoints	90
Bootblock Initialization Code Checkpoints	90
Bootblock Recovery Code Checkpoints	92
BIOS Recovery	93
Jumper and Connector Information	94
M/B Placement	94
Jumper Setting	96
Setting Jumper	96
FRU (Field Replaceable Unit) List	105
Veriton X2610/X2610G/X2618G/X2619G Exploded Diagram	106

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.