Home » Acer Manuals » Desktops » Acer Veriton X4610G » Manual Viewer

Acer Veriton X4610G Veriton X461x Desktop Series Service Guide - Page 13

Power supply, Quotation required on non-PFC 110/220V manual switch, PFC 220V, full range

View all Acer Veriton X4610G manuals

Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Power supply • Maximum power rating should satisfy the minimal requirement of system spec. • Protection circuits are required on over voltage, short circuit, over current,and over power protection. • Safety and EMI certification is required as system certification. • Quotation required on non-PFC 110/220V manual switch, PFC 220V, full range, and Energy Start 5.0 compliance. Chapter 1 5

Section	Page
Veriton X4610/X4610G/X4618G Service Guide	1
Revision History	2
Copyright	3
Disclaimer	4
Conventions	5
Table of Contents	7
System Tour	9
Features	9
Block Diagram	14
System Components	15
Front Panel	15
Rear Panel	16
Hardware Specifications and Configurations	17
Power Management Function(ACPI support function)	20
System Utilities	21
CMOS Setup Utility	21
Entering CMOS setup	22
Navigating Through the Setup Utility	22
Main	23
Advanced	24
Power	30
Security	31
Boot Options	33
Exit	34
System Disassembly and Assembly	35
Disassembly Requirements	35
Pre-disassembly Procedure	36
Removing the Side Panel	37
Removing the Front Bezel	38
Removing the Heat Sink Fan Assembly	39
Removing the Processor	41
Removing the Wireless LAN Card	43
Removing the VGA Card	44
Removing the Memory Modules	45
Removing the Optical Drive	46
Removing the Hard Disk Drive	47
Removing the COM2 Port Cable and Printer Port Cable	50
Removing the Power Supply	52
Removing the Internal Speaker	54
Removing the Mainboard	56
Removing the Intrusion Alarm Cable Assemby	59
Removing the Power Switch,OBR and LED Cable Assembly	60
Removing the Front I/O and Card Reader Boards	62
Assembly Requirements	64
Assembly Procedure	65
Install the Processor	66
Install the Heat Sink Fan Assembly	67
Install the Memory	68
Removing the Side Panel	69
Remove the Front Bezel and the ODD Bracket	70
Remove Outside Connect Slice	71
Install the I/O Shielding	71
Install the Main Board	72
Install the Internal Speaker	73
Connect the Cable	74
Install the Optica Drive Bracket	76
Install the Hard Disk Drive	77
Install the Optica Drive	79
Install the VGA Card	81
Install the Wireless LAN Card	82
Install the the Printer Port and COM Port Cable Cable	83
Install the Front Bezel	85
Install the Lift Side Panel	86
System Troubleshooting	87
System Check Procedures	88
Power System Check	88
System External Inspection	88
System Internal Inspection	88
Beep Codes	89
Checkpoints	90
Viewing BIOS checkpoints	90
Bootblock Initialization Code Checkpoints	90
Bootblock Recovery Code Checkpoints	92
BIOS Recovery	93
Jumper and Connector Information	94
M/B Placement	94
Jumper Setting	96
Setting Jumper	96
FRU (Field Replaceable Unit) List	104
Veriton X4610/X4610G/X4618G Exploded Diagram	105

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.