Acer XB270HU User Manual

Acer XB270HU Manual

Get Acer XB270HU PDF manuals and user guides View all Acer XB270HU manuals
Add to My Manuals
Save this manual to your list of manuals

Acer XB270HU manual content summary:

  • Acer XB270HU | User Manual - Page 1
    Acer LCD Monitor User's Guide
  • Acer XB270HU | User Manual - Page 2
    of this manual or supplementary documents and publications. This company makes no representations or warranties, either Acer Incorporated. Acer LCD Monitor User's Guide Model number Serial number Date of purchase Place of purchase Acer and the Acer logo are registered trademarks of Acer
  • Acer XB270HU | User Manual - Page 3
    The following are normal with the LCD monitor and do not indicate a problem. • Due to the nature of the all warnings and instructions marked on the product. Cleaning your monitor Please carefully follow these guidelines when cleaning the monitor: • Always unplug the monitor before cleaning. •
  • Acer XB270HU | User Manual - Page 4
    power cord from the electrical outlet. Safe listening To protect your hearing, follow these instructions. • Gradually increase the volume until you can hear it clearly and comfortably and without distortion. • After setting the volume level, do not increase it after your ears have adjusted. • Limit
  • Acer XB270HU | User Manual - Page 5
    power cord set, make sure that the new power cord meets the following requirements: detachable type, UL listed/CSA certified, type SPT-2, rated 7 A 125 V minimum, VDE approved or its equivalent, 4.5 meters (15 feet) maximum length. Product servicing Do not attempt to service this product yourself
  • Acer XB270HU | User Manual - Page 6
    and obey all signs and instructions. Potentially explosive atmospheres include areas . Switch off the device near gas pumps at service stations. Observe restrictions on the use of radio equipment burden placed on the environment. We at Acer are very conscious of the environmental effects of
  • Acer XB270HU | User Manual - Page 7
    instructions Do not throw this electronic device into the trash when discarding. To minimize pollution and ensure utmost protection of the global environment, please recycle. For more information on the Waste from Electrical and Electronics Equipment (WEEE) regulations, visit http://www.acer
  • Acer XB270HU | User Manual - Page 8
    section provides tips for more comfortable computer use. Finding your comfort zone Find your comfort zone by adjusting the viewing angle of the monitor, using a footrest, or raising your sitting height to achieve maximum comfort. Observe the following tips: • refrain from staying too long in one
  • Acer XB270HU | User Manual - Page 9
    sections provide suggestions on how to reduce eyestrain. Eyes • Rest your eyes frequently. • Give your eyes regular breaks by looking away from the monitor and focusing on a distant point. • Blink frequently to keep your eyes from drying out. Display • Keep your display clean. • Keep your head at
  • Acer XB270HU | User Manual - Page 10
    9399-2913 www.acer.it Declare under our own responsibility that the product: Product: LCD Monitor Trade Name: Acer Model Number: XB270HU SKU Number: XB270HU xxxxxx; ("x" = to establishing a framework for the setting of ecodesign requirements for energy-related product. Year to begin affixing
  • Acer XB270HU | User Manual - Page 11
    The following local Manufacturer /Importer is responsible for this declaration: Product: LCD Monitor Model Number: SKU Number: X B270HU X B270HU xxxxxx ; ("x" = 0~9, a ~ z, A ~ Z or Blank) Name of Responsible Party: Acer America Corporation Address of Responsible Party: 333 West San Carlos St
  • Acer XB270HU | User Manual - Page 12
    instructions Cleaning your monitor Connecting/disconnecting the device Accessibility Safe listening Warnings Using electrical power Product servicing Additional safety information IT equipment recycling information Disposal instructions adjust a setting Acer eColor Management User Troubleshooting DP
  • Acer XB270HU | User Manual - Page 13
    English 1 Unpacking Please check that the following items are present when you unpack the box, and save the packing materials in case you need to ship or transport the monitor in the future. LCD monitor Quick start guide DP cable (Option) USB cable (Option) AC power cord
  • Acer XB270HU | User Manual - Page 14
    English 2 ATTACHING/REMOVING THE BASE Install: Align the base with the stand and push the base towards the top of the monitor, and then rotate the base clockwise. Tighten the screw clockwise. Remove: Reverse the steps to remove the base.
  • Acer XB270HU | User Manual - Page 15
    optimize the best viewing position, you can adjust the height/tilt/ swivel/pivot of the monitor. • Height Adjustment After pressing the top of the monitor then you can adjust the height of the monitor. 1 2 150mm • Tilt Please see the illustration below for an example of the tilt range. Only
  • Acer XB270HU | User Manual - Page 16
    Swivel With the built-in pedestal, you can swivel the monitor for the most comfortable viewing angle. English 60o 60 • Monitor Pivot Before rotating the display,lift it to the top position and then push it back to the utmost degree. Rotate clockwise until the monitor stops at 90°. 90o 150
  • Acer XB270HU | User Manual - Page 17
    using 120 V AC: Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V. • For units using 220/240 V AC: Use a ) To make installation easier, so long as your system supports the DDC protocol, the monitor is able to plug-and-play. The DDC is a communication protocol through which the
  • Acer XB270HU | User Manual - Page 18
    6 Connector pin assignment English 20-pin color display signal cable* PIN No. Description 1 Lane0(p) 2 GND 3 Lane0(n) 4 Lane1(p) 5 GND 6 Lane1(n) 7 Lane2(p) 8 GND 9 Lane3(n) 10 Lane3(p) PIN No. 11 12 13 14 15 16 17 18 19 20 Description GND Lane3(n) Config1 Config2 AUX_CH (n) GND AUX_CH
  • Acer XB270HU | User Manual - Page 19
    8 Standard timing table English 1 QHD 2560×1440 60 Hz 2 QHD 2560×1440 85 Hz 3 QHD 2560×1440 100 Hz 4 QHD 2560×1440 120 Hz 5 QHD 2560×1440 144 Hz
  • Acer XB270HU | User Manual - Page 20
    cable to port. 4 Turn on the monitor and computer Turn on the monitor first, then the computer. This sequence is very important. 5 If the monitor does not function properly, please refer to the troubleshooting section to diagnose the problem. USB3.0 port -supporting fast charge USB3.0 port USB USB
  • Acer XB270HU | User Manual - Page 21
    : Press the Empowering Key to open the Acer eColor Management OSD and access the scenario modes. Brightness: Press this key to open the Brightness control and set it to your preferred level. Overdrive: Press this key to activate the Overdrive function and set it to either Normal or Extreme mode
  • Acer XB270HU | User Manual - Page 22
    eColor Management • Operation instructions 1 Press the " " Key to open the Acer eColor Management OSD and access the scenario modes. 2 Press " . N/A ECO mode Adjusts the settings to reduce power consumption. N/A Standard mode Default Setting. Reflects native display capability Enhances
  • Acer XB270HU | User Manual - Page 23
    The on-screen display (OSD) can be used for adjusting the settings of your LCD Monitor. Press any MENU key to open the OSD. You can use Exit to go back one level. Adjusting the Overdrive setting Open the Overdrive control and select the overdrive setting using the adjustment arrows. When you are done
  • Acer XB270HU | User Manual - Page 24
    MENU key to bring up the OSD. 2 Using the / keys, select setting you want to adjust. Picture from the OSD then navigate to the 3 Use the / keys to adjust the setting. 4 You can use the Picture menu to adjust Color settings, Brightness, Contrast, the Gamma setting and Color Temperature. EN-16
  • Acer XB270HU | User Manual - Page 25
    Adjusting OSD settings 1 Press any MENU key to bring up the OSD. 2 Using the directional keys, select want to adjust. OSD then navigate to the setting you EN-17
  • Acer XB270HU | User Manual - Page 26
    to bring up the OSD. 2 Using the / keys, select setting you want to adjust. Setting from the OSD, then navigate to the 3 The Setting menu can be used to adjust the screen Menu Language and other important settings including Input, Overdrive level, ULMB and Refresh Rate. 4 Select Power-off USB
  • Acer XB270HU | User Manual - Page 27
    key to bring up the OSD. 2 Using the / keys, select Information from the OSD to display some of the monitor's general information and settigns. G-SYNC Experience: G-SYNC requires an NVIDIA GeForce GTX650Ti BOOST GPU or higher. For more information, visit the nVidia® website: http://www.nvidia.com
  • Acer XB270HU | User Manual - Page 28
    sending your LCD monitor for servicing, please check the troubleshooting list below to see if you can self-diagnose the problem. DP mode Problem No picture visible LED status Blue Off Remedy Using the OSD, adjust brightness and contrast to maximum or reset to their default settings. Check the
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Acer LCD Monitor
User's Guide