Acer Aspire M5640 Service Guide for Aspire M1640 / M3640 / M5640 - Page 48

The following table describes the parameters found in this menu. Parameter Description Options Init Display Initialize the AGP video display before initializing First any other display device on the system. Thus the AGP display becomes the primary display. Reset Normally, you leave this field Disabled. Select [Enabled], Configuration Enabled to reset Extended System Configuration [Disabled] Data Data (ESCD) when you exit Setup if you have installed a new add-on and the system reconfiguration has caused such a serious conflict that the operating system cannot boot Resources This item allows user to assign PnP resource (I/O [Auto] Controlled By address, IRQ&DMA channels) for Plug and Play [Manual] compatible devices automatically or manually IRQ Resources When resource are controlled by manually, assign [Press Enter] each system interrupt a type , depending on the type of device using the interrupt. Option: [PCI Device]: Assign this IRQ for PCI device. [Reserved]: Reserve this IRQ for other device. PCI/VGA This option is only very rarely needed. It should be [Disabled], Palette Snoop left at "Disabled" unless a video device specifically [Enabled] requires the setting enabled upon installation. Maximum This field displays maximum payload size of the [128-4096] Payload Size system PCI 1/2 IRQ This item allows user to assign PCI IRQ for device [Auto], [3] , Assignment [4] , [5] , [6] , [7], [10] , [11] , [12] , [14] , [15] 42