Acer Extensa 6600 User Manual - Page 49

Change password, Boot to Windows XP. - xp drivers

Get Acer Extensa 6600 PDF manuals and user guides View all Acer Extensa 6600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

English 41 6 Select the desired driver/application and follow the instructions on screen to re-install. At first launch, Acer eRecovery prepares all the needed software and may take few seconds to bring up the software content window. Change password Acer eRecovery and Acer disk-to-disk recovery are protected by a password that can be changed by the user. Follow the steps below to change the password in Acer eRecovery. 1 Boot to Windows XP. 2 Press + to open the Acer eRecovery utility. 3 Enter the password to proceed. The default password is six zeros. 4 In the Acer eRecovery window, select Recovery settings and click Next. 5 In the Recovery settings window, select Password: Change Acer eRecovery password and click Next. 6 Follow the instructions on screen to complete the process. Note: If the system crashes, and will not boot to Windows, you can run Acer disk-to-disk recovery to restore the factory default image under DOS mode.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
41
English
6
Select the desired driver/application and follow the instructions on screen
to re-install.
At first launch, Acer eRecovery prepares all the needed software and may take
few seconds to bring up the software content window.
Change password
Acer eRecovery and Acer disk-to-disk recovery are protected by a password that
can be changed by the user. Follow the steps below to change the password in
Acer eRecovery.
1
Boot to Windows XP.
2
Press
<Alt> + <F10>
to open the Acer eRecovery utility.
3
Enter the password to proceed. The default password is six zeros.
4
In the Acer eRecovery window, select
Recovery settings
and click
Next
.
5
In the Recovery settings window, select
Password: Change Acer eRecovery
password
and click
Next
.
6
Follow the instructions on screen to complete the process.
Note:
If the system crashes, and will not boot to Windows, you can
run Acer disk-to-disk recovery to restore the factory default image
under DOS mode.