Airlink ASOHORL Quick installation guide
Airlink ASOHORL Manual
 |
View all Airlink ASOHORL manuals
Add to My Manuals
Save this manual to your list of manuals |
Airlink ASOHORL manual content summary:
- Airlink ASOHORL | Quick installation
guide - Page 1
FaFsatstEtEhtehrenrentetAdAadpatpetrer 10/100Mbps PCI Fast Ethernet Adapter User's Manual - Airlink ASOHORL | Quick installation
guide - Page 2
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If you suspect this product is causing interference, turn your computer on and off - Airlink ASOHORL | Quick installation
guide - Page 3
Introduction Thanks you for purchasing our 10/100Mbps Fast Ethernet Adapter. This guide is to provide the installation and usage of this adapter for network installers and users. The 10/100 network adapter complies to PCI 2.1 and PCI 2.2 specification and supports half/full duplex feature which can - Airlink ASOHORL | Quick installation
guide - Page 4
. y One UTP connector for 100Mbps or 10Mbps network speed. y Support Auto-negotiation function. y Built-in FIFO buffers to eliminate external memory. y Auto-setups IRQ and I/O address. y Supports early interrupt on transmit to increase performance. y Supports ODI driver for NetWare 3.x/4.x/5.x; NDIS - Airlink ASOHORL | Quick installation
guide - Page 5
y Transmission Rate : 10Mbps or 20Mbps 100Mbps or 200Mbps y Hardware Required : IBM compatible PC with available PCI slot ( PCI 2.1 or PCI 2.2 ) y IRQ Line : Assigned by system y I/O Address : Assigned by system y Drivers : ODI driver for NetWare 3/4/5 NDIS driver for LAN Manager, Windows 95 - Airlink ASOHORL | Quick installation
guide - Page 6
the computer chassis and put back the computer cover. 4. Connect the adapter to the network using twisted- pair cable. (2) Hardware Requirement for Wake On LAN (Depends on Models) yIf your motherboard support the PCI 2.1 only, then the motherboard must provide a 3-pin WOL connector. (Some computers - Airlink ASOHORL | Quick installation
guide - Page 7
support PCI 2.1 only, please follow the next procedure, 1. Unpack the 3-pin auxiliary power cable. 2. Insert the 3-pin auxiliary power cable into the connector on the adapter. 3. Attach the 3-pin auxiliary power cable to the connector on the PC motherboard. (4) Driver Installation Use the drivers - Airlink ASOHORL | Quick installation
guide - Page 8
44 Trouble-shooting If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub complies with the adapter specification, such as 10Mbps 10BaseT or 100Mbps 100BaseTX, then check the LED. The adapter - Airlink ASOHORL | Quick installation
guide - Page 9
your computer owner's manual or contact your adapter. 5. If the adapter still does not wake up, install a known good working Wake On LAN adapter and 3-pin auxiliary power cable in the PC and recheck the PC. For further assistance please contact Airlink+ technical support: 1-888-746-3238 support
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
 |
 |
Fast Ethernet Adapter
10/100Mbps PCI
Fast Ethernet Adapter
User’s
Manual
Fast Ethernet Adapter