Airlink ASOHOVIA Quick installation guide
Airlink ASOHOVIA Manual
 |
View all Airlink ASOHOVIA manuals
Add to My Manuals
Save this manual to your list of manuals |
Airlink ASOHOVIA manual content summary:
- Airlink ASOHOVIA | Quick installation
guide - Page 1
32-bit PCI-Bus 10/100Mbps ACPI Fast Ethernet Card User's Guide - Airlink ASOHOVIA | Quick installation
guide - Page 2
. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this user's guide, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in - Airlink ASOHOVIA | Quick installation
guide - Page 3
Additionally, the 32-bit PCI-Bus 10/100Mbps ACPI Fast Ethernet Card complies with ACPI, and PC99, and includes support for Remote Wake-Up by Magic Packet™, LinkChg and Microsoft®wake-up frame. About Fast Ethernet Fast Ethernet is a network technology specified by IEEE Standard 802.3u. It extends the - Airlink ASOHOVIA | Quick installation
guide - Page 4
technology allows networked PCs to to a network card when the PC is powered off. n A Wake-On-LAN network card that can recognize for the network card auxiliary power and one line for the card wake-up network card is always active and monitoring the network. When a wake-up packet is detected, the card - Airlink ASOHOVIA | Quick installation
guide - Page 5
Supports ACPI, PCI power management. • Half/Full duplex capability • Supports Full Duplex Flow Control (IEEE 802.3x) • Built-in FIFO buffers reduce overhead of memory transfers. • Drivers for all leading Network bus 10/100Mbps Fast Ethernet Adapter and its supporting hub/switch. A flashing green LED - Airlink ASOHOVIA | Quick installation
guide - Page 6
the 10/100Mbps PCI bus Fast Ethernet Card requires Hardware installation first, then BIOS manual to locate this connector. 5. Install the bracket screw, which secures the card to the cinouter chassis. 6. Replace the computer's cover and connect the network cable to newly installed network card - Airlink ASOHOVIA | Quick installation
guide - Page 7
run the CMOS Setup utility, and manually assign a non-conflicting Interrupt Number. Step 3, Driver Installation Before you connect the 10/100Mbps PCI bus Card to the network, you have to install the network driver first. The driver for each networking operating system is under a separate directory - Airlink ASOHOVIA | Quick installation
guide - Page 8
Troubleshooting If you experience any problems with the adapter, first verify that the appropriate driver is loaded, that the proper grade of cable is employed for the network connection, and that the supporting hub is functioning properly. 1. Ascertain that the adapter card is fully and firmly - Airlink ASOHOVIA | Quick installation
guide - Page 9
Specifications Standards: IEEE 802.3 10BASE-T IEEE802.3u 100BASE-TX ANSI/IEEE 802.3 Auto-negotiation IEEE 802.3x Full Duplex flow control PCI Local Bus Rev.2.1, 2.2 Host interface: 32-bit PCI 2.1, 2.2. Bus Master Wake-On-Lan: Magic Packet LinkChg Microsoft wake-up frame LED indicators: 100M
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
 |
 |
32-bit PCI-Bus 10/100Mbps
ACPI Fast Ethernet Card
User’s Guide