Alpine CDE-124SXM Owner's Manual (english) - Page 43
Right Rear - Speaker Output Lead Violet/Black - open box
UPC - 793276011138
View all Alpine CDE-124SXM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
BLUETOOTH interface Connector (CDE-123 only) Connect this to an optional BLUETOOTH INTERFACE. To use a hands-free mobile phone, an optional BLUETOOTH INTERFACE connection is required. For details on connection, refer to the Owner's Manual of the BLUETOOTH INTERFACE. You can also connect this to an external device (such as a portable player) by using Conversion cable (KCE-237B) for building up the AUX IN (sold separately). Note • Refer to "Setting the AUX REAR Setup Mode (AUX-R SET) (CDE-123 only)" on page 19. AUX-R ON : When the external device is connected. AUX-R OFF : When set to OFF, AUX REAR source cannot be selected. Steering Remote Control Interface Connector (CDE-123 only) To steering remote control interface box. For details, contact your Alpine dealer. Rear USB Connector (CDE-123 only) Connect this to an Flash Memory/Portable audio player or to an iPod/ iPhone. To use an iPod/iPhone, Interface cable for iPod connection is required. Notes • Use the supplied USB cable. If a USB cable other than the supplied is used, correct performance cannot be guaranteed. • Route the USB cable away from other cables. Antenna Receptacle Power Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicable. Note • This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier, or a signal processor, etc. Remote Turn-On Lead (Blue/White) Connect this lead to the remote turn-on lead of your amplifier. Audio Interrupt In Lead (Pink/Black) Connect this lead to the Audio interface output of a cellular phone which provides ground shorting when a call is received. Illumination Lead (Orange) This lead may be connected to the vehicle's instrument cluster illumination lead. This will allow the backlighting of the CDE-124SXM/CDE-123/CDE-122 to dim whenever the vehicle's lights are turned on. Switched Power Lead (Ignition) (Red) Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+)12V only when the ignition is turned on or in the accessory position. Battery Lead (Yellow) Connect this lead to the positive (+) post of the vehicle's battery. Ground Lead (Black) Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided. Right Front (+) Speaker Output Lead (Gray) Right Front (-) Speaker Output Lead (Gray/Black) Right Rear (-) Speaker Output Lead (Violet/Black) Right Rear (+) Speaker Output Lead (Violet) Left Rear (+) Speaker Output Lead (Green) Left Rear (-) Speaker Output Lead (Green/Black) Left Front (-) Speaker Output Lead (White/Black) Left Front (+) Speaker Output Lead (White) Fuse Holder (10A) SiriusXM Tuner connector (CDE-124SXM/CDE-123 only) Connect to a SiriusXM Tuner. Front Output RCA Connectors RED is right and WHITE is left. Rear Output RCA Connectors RED is right and WHITE is left. Subwoofer Output RCA Connectors (CDE-123 only) RED is right and WHITE is left. Front/Subwoofer Output RCA Connectors (CDE-124SXM/ CDE-122 only) RED is right and WHITE is left. Power Supply Connector RCA Extension Cable (sold separately) BLUETOOTH INTERFACE Connection Cable (Included with BLUETOOTH INTERFACE) Front AUX Input Terminal This terminal allows for input of audio from an external device (such as a portable player), using a commercially-available converter cable. Front USB Terminal Connect this to an Flash Memory/Portable audio player or to an iPod/ iPhone. To use an iPod/iPhone, Interface cable for iPod connection is required. To prevent external noise from entering the audio system. • Locate the unit and route the leads at least 10 cm away from the car harness. • Keep the battery power leads as far away from other leads as possible. • Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis. • If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information. • Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. 43-EN